Vax oasis complete V-133 Instruction Manual page 13

V-133 OasisComp User Guide v5.qxd:V-133 Oasis User Guide
Unlatch back part of recovery tank and (Fig 5/8)
Fig.5/8
Remove recovery tank front panel by sliding it straight up
(Fig 5/9).
Fig.5/9
Replace panel with converter. Slide converter halfway
down opening until it is firmly in place (Fig 5/10).
Fig.5/10
NOTE: Before connecting tube to cleaner, make sure black
tabs are extended by pulling tan collar toward tube.
Open door on hood labeled "Stair/ upholstery Cleaning
Connection".Press round solution tube connector onto
round projection inside door.
Press connector collar down firmly to ensure that it is fully
connected (Fig 5/11).
NOTE: The tank replaces in a hingelike manner.
All manuals and user guides at all-guides.com
Front panel
Converter
8/9/08
Fig.5/11
Position front of lid under tabs on front of tank. Rotate lid
down onto tank.
IMPORTANT: Make sure lid is secure on all sides
!
before cleaning.
For full suction, it is important that the recovery tank lid is
properly secured before cleaning. Reverse procedure to
remove hose and solution tube.
Raise carpet cleaner handle to upright position (Fig 5/12).
Tabs
Fig.5/12
Attach tool to connector end of hose by sliding it onto
connector until the tab locks it securely.
Using your thumb, push forward and up on the latch to
remove tool as shown (Fig 5/13).
Fig.5/13
Ensure that the brush selector mode is set to the
OFF position.
14:44 Page 13
Vax Careline 0870 606 1248
Connecting tube
Tab
Latch
13
cleaning