Frymaster FPD65 Series Installation & Operation Manual page 37

5.3.2 Filtering Tools
Assemble tools to be used for filtering. These are supplied with the filter starter kit included with
the fryer/filter system:
Frypot/Filter Brush– used to clean frypot and filter pan sides and bottom, heating tubes, and
to dislodge sediment during filtration or shortening change.
Clean-Out Rod– used to dislodge heavy debris in the drain tube (when needed).
The following tools are not required, but are recommended:
Measuring Cup– used to measure filter powder.
Fine Mesh Skimmer– used to remove large debris.
Note: Prior to proceeding, put on safety goggles, neoprene gloves and heavy
vinyl apron.
Follow specific store procedures when filtering the fryer. In the event store
procedures are not available, the following instructions can be followed until specific
Filter ONLY one frypot at a time. The filter pan is designed to hold the contents of
FRYMASTER FPD65 SERIES GAS FRYERS
CHAPTER 5: FILTRATION OPERATION
NOTICE
store procedures are obtained.
WARNING
one frypot ONLY.
5-5