Aiming The Camera - FUJICA AX-3 Owner's Manual

* For further information, read the Auto Winder instruction manual.
5. SETTING THE FILM SPEED SELECTOR
After loading the film, be sure to #t the Film Speed Selector because your
pictures will not be properly exposed if it is not set for the speed of
the film loaded in the camera.
The speed of the film you are using is printed on the film box.
1. While pressing in the Film Speed Selector Lock (a white button beside
the Film Speed Selector), turn the selector dial and set it for the speed
of the film you are using, that is, if you are using an ISO/ASA 100 film,
set the number 100 opposite the Film Speed Setting Mark.
* The marks labeled +1 and -1 on each side of the Film Speed Setting mark
are used for making exposure compensation. Be sure to use the center mark
for setting the Film Speed Selector.
2. The lines etched between the numbers on the Film Speed Selector
represent the ISO/ASA speeds shown above.
3. The corresponding ISO/ASA and DIN film speeds are as follows:

6. AIMING THE CAMERA