Advertisement
Quick Links
Advertisement
Related Manuals for ATOMRC Seal
Summary of Contents for ATOMRC Seal
- Page 1 User Manual Seal...
- Page 2 Introduction/简介 The seal is classic glider design,easy for beginners,with detachable wing design,user can choose 1100mm wing span or use extend wing to 1500mm wingspan for different style of Fly.Design for FPV,the ESC,FC VTX and Camera all have installation area.Side door for install Flight controller,easy to wiring and maintain.Easy to build and maintain.
- Page 3 （User need glue the plane） Wood Plate ATOMRC 2212 1400KV MOTOR FOXEER Razer NANO 1200TVL Description ATOMRC Exceed 30A Ballhead Push Rods ATOMRC Exceed 1.5W VTX BLS 2~4S 5V3A BEC ESC ATOMRC Exceed 9g Servo* 4 Battery Strap 5.8G 2dB Antenna 8 Inch Prop...
- Page 4 Installation/安装指南 G l u e t h e f r a m e , V T X m o u n t a n d M o t o r m o u n t . 将机身框架⽊⽚和图传固定的⽊⽚粘贴到机身上。 Glue the frame to the other side of fuselage，then glue the fuselage. 将框架⽊⽚粘贴到另⼀侧，然后粘贴左右机身。...
- Page 5 Install the rudder control surface, servo and push rod. 安装⽅向舵舵⻆，舵机及拉杆。 Install the elevator control surface, servo and push rod. 安装⽅向舵舵⻆，舵机及拉杆。 Glue the tail. 粘接平尾。 Glue the body,and hatch lock. 粘接机尾，安装舱盖扣。...
- Page 6 9※ Glue the main carbon tube, tube clip. 粘接机翼碳管，管夹。 10※ Please do not glue the dark part shown above, otherwise the carton tube will to tight to install. 粘接管夹时，请勿在灰⾊区域粘接胶⽔，以免胶⽔溢出导致碳管难以插⼊。 Glue the side plate and control surface reinforcement carbon rod. 粘接机翼侧板，舵⾯加强⽚和舵⻆。 Glue the servo, install the push rod.
- Page 7 Assemble the wing to the body, tighten the screw to lock the wing. 安装机翼，固定管夹螺丝锁定机翼。 Glue the plastic skid. 粘接机腹防摩⽚。 Install the motor and ESC. 安装电机电调。 Install the Camera, install the camera cable. 安装摄像头，固定摄像头线。...
- Page 8 Install the GPS, VTX and Flight Controller. 安装GPS，图传及⻜控。 How to installation 1100mm Wing Span ⼩翼展模式切换 1500mm 1100mm 10*8mm 600mm 200mm If user want use 1100wing span, the wing carbon tube need change 200mm. 若⽤户想使⽤1100mm翼展，需将机翼中间碳管切换⾄200mm.
- Page 9 ESC Information/电调说明 1.The ESC included with the model has a safe start.If the motor battery is connected to the ESC and the throttle stick is not in the low throttle or off position,the motor will not start untill the throttle stick is moved to the low throttle or off...
- Page 10 LED, short press to switch power, 1 bar means 200mW, 2 bar means 800mW, 3 bar means 1500mW. 1, ⻓按设置按键三秒，进⼊波段设置模式。 2，在设置模式下，短按按键切换波段。 3，再次⻓按按键三秒钟，进⼊频道切换模式，短按按键切换频道。 4，再次⻓按按键三秒钟，进⼊切换功率模式，短按按键切换功率，数码管⼀条 为200mw，两条为800mw, 三条为1500mw。 Please make sure antenna is installed before power on, otherwise the VTX will fried!!! 图传发射机通电前务必确认天线已安装妥当，否则发射线会烧毁。 Please download the latest user manual at www.atomrc.com/pages/download...
Need help?
Do you have a question about the Seal and is the answer not in the manual?
Questions and answers