Advertisement
Quick Links
SHPE2000, SHPE2000RED, SHPE2000YEL
Series SaltDogg
®
Electric Drive Poly Hopper
Spreader
2.0 cubic yards
U.S. PATENT 9,562,333
Serial Number 21000 and Above.
Table of Contents
General Information .....................................................................1
Safety Precautions .......................................................................1
Warranty Information ...................................................................2
Installation Instructions ............................................................ 2-4
Spreader Operation .....................................................................5
Spreader Maintenance .................................................................5
Repair Parts & Drawings .........................................................6-10
General Information
Spreader models:
• SHPE2000- spreader with standard length chute
• SHPE2000X- spreader with extended length chute
Overall Length: 96 inches
Overall Width: 48 inches
Overall Height: (installed): 41.5 inches
Empty Weight: 560 lbs. (standard chute), 564 lbs. (extended chute)
Capacity Struck: 2.0 cu. yd.
Average Installation Time: 3 hrs.
Vehicle Requirements
• 3/4 or 1 ton pick-up truck above 8500# GVWR.
• 135 AMP or higher alternator is recommended.
Materials Recommended to Spread
CAUTION
Do not overload vehicle beyond the vehicle's GVWR or GAWR.
Check vehicle's load rating certification sticker for maximum
vehicle capacity.
Average Material Weights
Materials to use
Fine Salt-Dry
Coarse Salt-Dry
Sand/Salt up to 50/50 Mix-Dry
Note: To calculate the total spreader weight (including ice
control material), add the empty spreader weight plus the ice
control material and spreader accessories.
Installation Instructions
Weight (pounds per cubic yard)
2,250
1,431
2,700
Phone (440) 974-8888 • Fax (440) 974-0165
Toll-Free Fax 800-841-8003 • saltdogg.com
SHPE2000 SALTDOGG SPREADER WARRANTY INFORMATION
This warranty replaces all previous warranties and no employee of this
company is authorized to extend additional warranties, or agreements, or
implications not explicitly covered herein.
Buyers Products Company warrants all parts of the product to be free
from defects in material and workmanship for a period of two (2) years.
Parts must be properly installed and used under normal conditions.
Normal wear is excluded.
Any part, which has been altered, including modifications, misuse, acci-
dent, or lack of maintenance will not be considered under this warranty.
The sole responsibility of Buyers Products Company under this warranty
is limited to repairing or replacing any part(s), which are returned, pre-
paid, 30 days after such defect is discovered, and returned part(s) are
found to be defective by Buyers Products Company.
Authorization from Buyers Products Company must be obtained before
returning any part. The following information must accompany defective
parts returned to Buyers Products Company: RMA #, spreader model,
serial number, date installed, and distributor from whom purchased.
Buyers Products Company shall not be liable for damage arising out of
failure of any unit to operate properly, or failure, or delay in work, or for
any consequential damages. No charges for transportation or labor per-
formed on any part will be allowed under this warranty.
1
9049 Tyler Blvd. • Mentor, Ohio 44060
—continued inside
Advertisement
Related Manuals for Buyers SaltDogg SHPE2000
Summary of Contents for Buyers SaltDogg SHPE2000
- Page 1 Overall Length: 96 inches Overall Width: 48 inches Buyers Products Company warrants all parts of the product to be free from defects in material and workmanship for a period of two (2) years. Overall Height: (installed): 41.5 inches Parts must be properly installed and used under normal conditions.
- Page 2 Safety Precautions F. Attach the Chute Assembly to the spreader. First, hook the Chute to the spreader by openings in the Chute’s handle. WARNING Observe the following Safety Precautions before, during and Fig. 2 after operating this spreader. By following these precautions and common sense, possible injury to persons and potential damage to this machine may be avoided.
- Page 3 TO FIT BED WIDTH WARNING Fig. 4 Do not drill holes into fuel tanks, fuel lines, through electrical TO FIT BETWEEN 2" X6" wiring, etc that may be damaged by drilling. SPREADER AND FRONT OF THE BED 2. Install Control Box & Vehicle Wiring Harness (Fig. 7). NOTE: THIS IS A WIRE GROUND ELECTRICAL SYSTEM! NO CONNECTIONS TO TRUCK'S FRAME OR BODY ALLOWED! ALWAYS DISCONNECT BATTERY BEFORE ATTEMPTING...
- Page 4 3001379 CB120PB Fig. 7 BATTERY POSITIVE BATTERY NEGATIVE 3035933 3006724 3014199 2. When filling hopper use the supplied screen to prevent large chunks of material and debris in the material to get into hopper and cause damage. 3. Material must never be left in hopper for an extended period of time.
- Page 5 Material Flow Adjustments Spreader Maintenance Always use screen during spreader operation! Various 1. Wash spreader after every use. Make sure no material is left materials have different moisture absorption rate, some under auger and/or inside trough. materials may not perform as desired. Therefore, the 2.
- Page 6 Repair Parts - Standard Chute Assembly Repair Parts - Extended Chute Assembly Bills of Material Bills of Material ITEM PART NO. QTY. DESCRIPTION ITEM PART NO. QTY. DESCRIPTION 3025063 CHUTE POLY, SHPE STD. LENGTH 3007526 CHUTE POLY. EXT. LENGTH 3033665 BRACKET WELDMENT, CHUTE 3006833 GEAR MOTOR 12 VDC.
- Page 7 Repair Parts-Hopper Assembly Bills of Material ITEM PART NO. QTY. DESCRIPTION ITEM PART NO. QTY. DESCRIPTION 3007821 STRAIN RELIEF BUSHING 3035920 HOPPER POLY 2 CU YD 3020713 CONNECTOR, MALE, FEMALE 3036867 HOPPER POLY 2 CU YD, RED 3022955_ HOSEGREASE, 1/8 NPT, 36 IN LONG 3036868 HOPPER POLY 2 CU YD, YELLOW H3309X2...
- Page 8 CONTROLLER KIT 3036574 HARDWARE KIT SHPE2000 #3024188 3014199 CONTROLLER, SHPE, SALT DOGG 3006724 WIRE HARNESS, MAIN PLUG BUYERS P.N. 3007295 3035936 KIT POWER CABLE REPLACES 3006842 1496505 HOLD DOWN KIT, SPREADER (4 STRAPS) WIRE HARNESS TO SPINNER GEAR MOTOR 3035377...