Emerson RTM-ATCA-F125 Installation And Use Instruction page 25

7. Fully insert the blade and lock it to the shelf by squeezing the lever and the latch together
and turning the handles towards the face plate.
8. Tighten the face plate screws which secure the RTM to the shelf.
9. If the front blade has already been installed (as in step 2), activate the front blade by
squeezing its lower lever and latch together and press it back into the face plate.
10.If the front blade has not been installed, proceed with the installation instructions in the
front blade installation and use manual.
Make sure that the handles of both the RTM and the front blade are closed in order to power
up the blade and RTM payload.
RTM-ATCA-F125 Installation and Use (6806800K30C)
Hardware Preparation and Installation
27