Emerson Smart Wireless THUM Adapter Quick Installation Manual

Hide thumbs

Advertisement

Quick Links

Quick Installation Guide
00825-0100-4075, Rev DA
July 2011
Smart Wireless THUM™ Adapter
¢00825-0100-4075[¤
Smart Wireless THUM Adapter
Start
Wireless Considerations
Bench Top Configuration
Step 1: Physical Installation
Step 2: Verify Operation
Reference Information
Product Certifications
EC Declaration of Conformity
End

Advertisement

loading

  Related Manuals for Emerson Smart Wireless THUM Adapter

  Summary of Contents for Emerson Smart Wireless THUM Adapter

  • Page 1 Quick Installation Guide 00825-0100-4075, Rev DA Smart Wireless THUM Adapter July 2011 Smart Wireless THUM™ Adapter Start Wireless Considerations Bench Top Configuration Step 1: Physical Installation Step 2: Verify Operation Reference Information Product Certifications EC Declaration of Conformity ¢00825-0100-4075[¤...
  • Page 2: Smart Wireless Thum Adapter

    F (952) 949-7001 Enquiries@AP.EmersonProcess.com IMPORTANT NOTICE This installation guide provides basic guidelines for the Smart Wireless THUM Adapter. It does not provide instructions for detailed configuration, diagnostics, maintenance, service, troubleshooting, or installations. Refer to the THUM Adapter Reference Manual (document number 00809-0100-4075) for more instruction. The manual and this QIG are also available electronically on www.rosemount.com.
  • Page 3: Wireless Considerations

    Quick Installation Guide 00825-0100-4075, Rev DA Smart Wireless THUM Adapter July 2011 IRELESS ONSIDERATIONS Power Up Sequence Power should not be applied to any wireless device until the Smart Wireless Gateway (“Gateway”) is installed and functioning properly. Wireless devices should also be powered up in order of proximity from the Gateway, beginning with the closest.
  • Page 4: Power Supply

    Quick Installation Guide 00825-0100-4075, Rev DA Smart Wireless THUM Adapter July 2011 Power Supply Minimum loop load of 250 Ohms. ® The THUM Adapter communicates via and derives power from a standard 4-20 mA/HART loop. The THUM Adapter causes a small voltage drop on the loop which is linear from 2.25 V at 3.5 mA to 1.2 V at 25 mA.
  • Page 5: Step 1: Physical Installation

    Quick Installation Guide 00825-0100-4075, Rev DA Smart Wireless THUM Adapter July 2011 Figure 3. THUM Adapter Only, Powered by a 24 V Power Supply with 1200 Ohm resistor to limit current to 20 mA THUM Adapter Green Ground 20 mA...
  • Page 6: Remote Mount

    Quick Installation Guide 00825-0100-4075, Rev DA Smart Wireless THUM Adapter July 2011 Remote Mount Remote Mount: The THUM Adapter is mounted separate from the wired device housing and then connected to the wired device using conduit or other suitable means.
  • Page 7 Quick Installation Guide 00825-0100-4075, Rev DA Smart Wireless THUM Adapter July 2011 Wiring Diagrams The following is a list of the figure titles and page numbers for each direct mount and remote mount wiring diagram: Figure 6 - Direct Mount Wiring Diagram for 2-Wire Device on page 8...
  • Page 8: Quick Installation Guide

    Quick Installation Guide 00825-0100-4075, Rev DA Smart Wireless THUM Adapter July 2011 Figure 6. Direct Mount Wiring Diagram for 2-Wire Device THUM Adapter Wired Device Green Ground 4-20 mA Loop + Black Power 4-20 mA Loop - White Supply Yellow Splice Connector Load Resistor 250 ...
  • Page 9 Quick Installation Guide 00825-0100-4075, Rev DA Smart Wireless THUM Adapter July 2011 Figure 8. Direct Mount Wiring Diagram for 2-Wire Device with Resistor THUM Adapter Wired Device Green Ground 4-20 mA Loop + Black Power 4-20 mA Loop - White...
  • Page 10 Quick Installation Guide 00825-0100-4075, Rev DA Smart Wireless THUM Adapter July 2011 Figure 10. Direct Mount Wiring Diagram for 4-Wire Passive Device THUM Adapter Splice Connector Wired Device Green 4-20 mA Loop + Ground Power 4-20 mA Loop - Black...
  • Page 11 Quick Installation Guide 00825-0100-4075, Rev DA Smart Wireless THUM Adapter July 2011 Figure 12. Direct Mount Wiring Diagram for 4-Wire Passive Device with Resistor THUM Adapter Wired Device Splice Connector Green 4-20 mA Loop + Ground 4-20 mA Loop -...
  • Page 12 Quick Installation Guide 00825-0100-4075, Rev DA Smart Wireless THUM Adapter July 2011 Figure 14. Direct Mount Wiring Diagram for 4-Wire Active Device THUM Adapter Wired Device Splice Connector 4-20 mA Loop + Green Ground Yellow 4-20 mA Loop - Input...
  • Page 13 Quick Installation Guide 00825-0100-4075, Rev DA Smart Wireless THUM Adapter July 2011 Figure 16. Direct Mount Wiring Diagram for 4-Wire Active Device with Resistor THUM Adapter Splice Connector Wired Device Green 4-20 mA Loop + Ground Yellow 4-20 mA Loop -...
  • Page 14 Quick Installation Guide 00825-0100-4075, Rev DA Smart Wireless THUM Adapter July 2011 Figure 18. Direct Mount Wiring Diagram for 4-Wire Active Device with No 4-20 mA Loop THUM Adapter Splice Connector Wired Device Green  Load Resistor 250 Ground Yellow...
  • Page 15 Quick Installation Guide 00825-0100-4075, Rev DA Smart Wireless THUM Adapter July 2011 Figure 20. THUM Adapter only, Powered by a 24 V Power Supply with 1200 Ohm resistor to limit current to 20 mA THUM Adapter Ground Green 24 V...
  • Page 16: Device Network Configuration

    Quick Installation Guide 00825-0100-4075, Rev DA Smart Wireless THUM Adapter July 2011 Device Network Configuration In order to communicate with the Smart Wireless Gateway, and ultimately the Information System, the transmitter must be configured to communicate with the wireless network. This step is the wireless equivalent of connecting wires from a transmitter to the information system.
  • Page 17: Loop Current Test

    Quick Installation Guide 00825-0100-4075, Rev DA Smart Wireless THUM Adapter July 2011 Loop Current Test To verify that the THUM Adapter will work under all conditions, a loop current test should be performed. This test will exercise the loop under the highest possible voltage drop conditions.
  • Page 18 Quick Installation Guide 00825-0100-4075, Rev DA Smart Wireless THUM Adapter July 2011 6. Remove loop from high alarm value. Figure 23. AMS Configure screen...
  • Page 19: Step 2: Verify Operation

    Quick Installation Guide 00825-0100-4075, Rev DA Smart Wireless THUM Adapter July 2011 2: V ERIFY PERATION Operation can be verified in three locations: by using the Field Communicator, at the ™ Gateway via the Smart Wireless Gateway’s integrated web server, or via AMS Wireless Configurator.
  • Page 20: Troubleshooting

    Quick Installation Guide 00825-0100-4075, Rev DA Smart Wireless THUM Adapter July 2011 Troubleshooting If the device is not operating properly, refer to the troubleshooting section of the manual. The most common cause of incorrect operation is the Network ID and Join Key. The Network ID and Join Key in the device must match that of the Smart Wireless Gateway.
  • Page 21: Product Certifications

    Emerson Process Management Asia Pacific Private Limited — Singapore European Directive Information The EC declaration of conformity for all applicable European directives for this product can be found at www.rosemount.com. A hard copy may be obtained by contacting an Emerson Process Management representative. ATEX Directive (94/9/EC) Emerson Process Management complies with the ATEX Directive.
  • Page 22: North American Certifications

    Quick Installation Guide 00825-0100-4075, Rev DA Smart Wireless THUM Adapter July 2011 Hazardous Locations Certificates North American Certifications Factory Mutual (FM) Approvals I5 FM Intrinsically Safe and Non-incendive Intrinsically Safe for Class I/II/III, Division 1, Groups A, B, C, D, E, F, and G.
  • Page 23 Quick Installation Guide 00825-0100-4075, Rev DA Smart Wireless THUM Adapter July 2011 IECEx Certifications I7 IECEx Intrinsic Safety Certificate No.: IECEx BAS 09.0050X Ex ia IIC T4 (-50 °C T 70 °C) IP66 Table 3. Input Parameters Loop Power Ui = 30 V Ii = 200 mA Pi = 1.0 W...
  • Page 24: Gost Certifications

    Quick Installation Guide 00825-0100-4075, Rev DA Smart Wireless THUM Adapter July 2011 GOST Certifications IM Intrinsically Safe Ex ia IIC T4 (-50 °C T 70 °C) Ex nA IIC T4 (-50 °C T 70 °C) IP66...
  • Page 25: Ec Declaration Of Conformity

    Quick Installation Guide 00825-0100-4075, Rev DA Smart Wireless THUM Adapter July 2011 EC Declaration of Conformity No: RMD 1077 Rev. B Rosemount Inc. 8200 Market Boulevard Chanhassen, MN 55317-6985 declare under our sole responsibility that the product, Model 775 manufactured by, Rosemount Inc.
  • Page 26 Quick Installation Guide 00825-0100-4075, Rev DA Smart Wireless THUM Adapter July 2011 EC Declaration of Conformity No: RMD 1077 Rev. B EMC Directive (2004/108/EC) EN 61326-1: 2006 R&TTE Directive (1999/5/EC) EN 301 489-17: V1.3.2 (2007-6) EN 61010-1: 2001 (Second Addition) EN 300 328 V 1.7.1 (2006-10)
  • Page 27 Quick Installation Guide 00825-0100-4075, Rev DA Smart Wireless THUM Adapter July 2011 EC Declaration of Conformity No: RMD 1077 Rev. B ATEX Notified Bodies for EC Type Examination Certificate Baseefa. [Notified Body Number: 1180] Rockhead Business Park Staden Lane Buxton, Derbyshire...
  • Page 28 Quick Installation Guide 00825-0100-4075, Rev DA Smart Wireless THUM Adapter July 2011...