Table of Contents
Advertisement
1-3-6. Optical Block Assembly-2 and U Board
Lead with connector
(LVDS)
Flat clamp
Marking is printed
on the top.
CN301
CN400
CN601
CN801
CN600
CN600
CN400
When installing the harness,
QA board
place the harness at a right
angle.
1-3-7. CB Board
C shield case
assembly
CA board
CA board
CN1003
CN1001
Note:
When attaching the CB board to the
CA board, insert the two connectors
and press them securely.
VPL-GH10
2 Four screws
4 Optical block assembly
Front Side
of Unit
Two holders
QA board
7 Two interconnections
(board to board)
CN5001
CN6001
8 CB board
5 Two radiation
sheets (12-12)
3 Five screws
(+PSW 3 x 8)
(+PSW 4 x 16)
CN20
Note in operation:
Do not damage the harnesses.
When the Heat plate (CY) is
removed, the RADIATION SHEET
(12-12) and the RADIATION SHEET (Q) cannot be re-used.
When replacing them, replace them with new parts without re-use.
6 Radiation sheet (Q)
Gasket (DTT B)
4 Heat plate (CY)
Note:
Before installing the Shield cover (C),
confirm that the Gasket (SP BG) is not
turned outward or not peeled off.
Gasket (SP BG)
1 Four screws
(+PSW 3 x 8)
5 Screw
(+BVTP 3 x 12)
6 U board
3 Two dowels
1 Four screws
(+PSW 3 x 8)
2 Shield cover (C)
Shield
cover (C)
Gasket
(SP BG)
1-7
Advertisement
Table of Contents
