Figure 16 Enabling Test Mode; Figure 17 Assigning A Test Number - Cardionics PAT Operator's Manual

Step 2. Assuming that you have already set up a password (see section 3.4), enter your
Name first. Then click on "Enable Test Mode. Next, decide if you want to display a
phonocardiogram on your test. Make your selection here. Then Log Out by clicking here.
Figure 16 Test Mode
Set Up Page
Step 3. A Test Number must be assigned to any lecture that you wish to give as a test. To
assign a test number, click on the Name of the Instructor, then click on Test Number.If the
instructor has multiple lectures, a test number can be assigned to each.

Figure 17 Assigning a Test Number

Step 4. Select Lecture Sequence (Figure 15 above). Then Select Instructor, Select Test
number and click on Start (Figure 17).
Step 5 After completion of the test, be sure to log out.
If you wish to review the test assignments, click on "View Summary of Test Assignments." See
Figure 18. The following dialog box of test assignments will be seen.
15