Drive Unit Oil - Change; Interior Air Filter - Check/Clean/Change - Kubota U50-5 Operating Instructions Manual

Drive unit oil - change

Only change the oil when the drive unit is warm to the hand; if not, drive the machine warm.
Park the machine on level ground so that the drain plug (figure below, position 3) is positioned at the bottom.

Place a catch tray with a minimum capacity of 2 l under the drain plug.

Remove the drain plug and let the oil drain completely. Install

the drain plug with a new sealing ring on it.
Remove the oil filler plug (2) and oil level screw (1).

Fill oil as specified in the "Operating materials" section

(page 180). The oil level is the lower edge of the thread.
Capacities: 0.9 l
Refit the oil filler plug and the set screw with a new sealing ring and tighten it.

Perform the same service on the second drive unit.


Interior air filter - check/clean/change

If the machine is operated in a particularly dusty envi-
ronment, the interior air filter must be checked more of-
ten.
Open the heating and air-conditioner unit service cover

(page 157).
Remove the screw (1).

Open the cover plate (2).

Remove the interior air filter (3).

Checking
Inspect the interior air filter for contamination and damage. In case of heavy contamination, replace the interior

air filter.
212
Maintenance
2 2 1 1
3 3
1 1 2 2
KX060-05_153
3 3
KX060-05_154
W9272-8135-1
05/2020