Converting To Type Of Propane - GASLAND chef GH1304SS Installation Instructions Manual

Converting To Type Of Propane

WARNING:This appliance can be used with Propane and Natural gas. It is shipped
from thfactory adjusted for use with Natural gas: Conversion orifices are located in
accessories package. Follow the instructions packaged with the orifices for gas
conversion.
1. Air supply valve and cooktop valve need to be closed, unplug the power plug
for AC model.
2. When the gas pressure regulator is in NG state and need to be converted to
Propane regulator, and then counterclock wise unscrew the marked NG
threaded rod, reverse the threaded rod, turn the LP arrow upwards and
tighten it to the screw cap, then install the cap back to the gas pressure
regulator. The gas pressure regulator gas conversion needs to be used with
the accessory kit(See Burner Configuration for detailed Injector specifications).
3. Remove the burners, burner caps, and screw out the Injector from the burner
bases. Then install those Injector in the Conversion Kit bag to each burner
base correspondingly. Save the orifices removed from the appliance for future
use.
4. Input inlet pressure of 11 in w.c.(2740 Pa ), coat the Injector joints and the gas
pressure regulator joints with moderate amounts of soapy water, there shall be
no bubbling.
5. Place the burner, burner cap, check if the position between the ignition pin
and the burner is correct, and then open the valve, AC model plugged in the
power plug. Leakage test please refer to page 13 "Gas Connection And
Check" section.
6. Test the outlet pressure, the pressure is required to be 10±1 in w.c. If it cannot
meet the scope of the requirements, need to unscrew the pressure regulator
nut as Fig.21, rotate slightly to adjust the white plastic parts inside the
pressure regulator.
1 (844) 538-7890
support@gaslandchef.com
Fig.21
www.gaslandchef.com
3330-A Marathon Ct Charleston, SC 29418
16