Makita SK40GD Instruction Manual page 71

SK10GD
[Loopback switch system]
NOTE:
The height of the horizontal line beam can be easily adjusted by using the tripod
(optional accessory).
It can be fine-adjusted from either side by turning the fine-adjustment knob.
1
Fine-adjustment mechanism
The stand prevents the product from toppling over.
When using ceiling / wall mounts (optional accessory), remove the stand.
1
NOTE:
Do not hold the stand to lift the product, or to attach or remove the battery.
The product may fall.
NOTE: About the rubber foot caps
Use the rubber caps to prevent the floor from being scratched or when the floor is
slippery. Rubber caps are supplied as standard.
These can be removed before use on uneven surfaces such as concrete floor.
Lower dot beam
1: Fine-adjustment knob
1: Stand
19 ENGLISH
Lower dot beam