All of us at Burson Audio would like to thank and congratulate you for purchasing the Burson Playmate 2. We sincerely believe that your new Burson Playmate 2 is an intelligent investment and that it will bring you many years of musical enjoyment and satisfaction.
After carefully unpacking your Burson Playmate 2, inspect for any shipping damage and call your dealer immediately if any is found. Do not plug your Burson Playmate 2 into any outlet if you find shipping damage. Please save all packing materials so the unit can be easily and safely shipped if the need arises.
Never connect or disconnect the RCA or XLR output cables from the Playmate 2 while music is playing. This could damage the Playmate 2. Please stop the music source before disconnecting.
FIR Filters See a visual representation of the various FIR filter settings below. Break Wall CMFR Reserved AP Fast MP Slow MP Fast LP Fast LP Slow...
Page 7
Opamp Change & Upgrade The Burson Playmate 2 allows opamp changing to customise its sound to the owner’s preference. When changing opamps, please be aware of the following: The opamp power supply voltage in the Burson Playmate 2 is +/-15V. Always remove the power supply before opening up the unit.
The Initial Powering up Make sure volume control has been turned to minimal when using your Playmate 2 for the first time. Always power on your source machine first and your power amp last. When powering down your system reverse these steps.
Burson Composer 3. Burson will not pay for loss of use or inconvenience caused by the failure of a Burson Composer 3. Burson will not pay for damage caused to other audio components caused by the failure of the Burson Composer 3 within the limits allowed by Australian Law.