Check / Add Engine Oil; Check / Change Air Filter; Check Hydraulic Oil Level; Hydraulic Oil Filter Change - Ferris IS4500ZBL3561 Operator's Manual

Is4500z series zero turn riding mower
Table of Contents

Advertisement

CHECK / ADD ENGINE OIL

Refer to Figure 13 for dipstick and oil fill locations.
Refer to the engine owners manual for specific engine
oil check and fill procedures. Also refer to the engine
owners manual for specific engine oil and filter change
procedures.

CHECK / CHANGE AIR FILTER

Refer to the engine owners manual for specific air filter
service procedures.

CHECK HYDRAULIC OIL LEVEL

NOTE: Do not open the hydraulic oil reservoir unless oil
is being added.
1. Visually check that the hydraulic oil level is filled to
the recess area (A, Figure 14) of the hydraulic oil
reservoir.
2. If necessary, remove the reservoir cap (B) and add
either Mobil 1™, 15W-50 synthetic oil or Castrol
Syntec™ 5W-50 oil. DO NOT use conventional oils.
Make sure area around the filler neck is free of dust,
dirt, or other debris.

HYDRAULIC OIL FILTER CHANGE

Change Interval: Every 500 Hours
Filter Part Number: 21357
NOTE: Removing the oil filter from the filter base will
drain the oil reservoir. Have a suitable container ready
to catch any spilled oil. Ferris recommends this be a
dealer-only service item.
1. Locate the hydraulic oil filter (A, Figure 15) behind
the oil reservoir.
2. Fill the new filter with oil. Lubricate the new filter
seal with a few drops of oil.
3. Remove the oil filter and quickly thread the new filter
onto the filter base until the gasket makes contact,
then tighten 3/4 of a turn more.
4. Refill reservoir with fresh oil to replace any oil lost
during filter change.
5. Raise the rear of the unit and secure with jackstands.
Chock the front wheels to prevent the unit from
rolling. Run the unit for several minutes to purge any
air from the hydraulic system and check the hydraulic
oil level.
IMPORTANT NOTE: Use caution after changing the fil-
ter; air in the hydraulic system may affect the respon-
siveness of the control levers. Repeat step 5 until the air
is out of the system.
A
Gas Model
Figure 13. Change Oil & Filter
A.
Oil Fill Cap
B.
Crankcase Dip Stick
B
Figure 14. Hydraulic Oil Reservoir
A.
Tank Recess ("FULL" level)
B.
Cap
Figure 15. Hydraulic Oil Filter Location
A.
Oil Filter
21
Regular Maintenance
Diesel Model
B
A
B
A
A

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Is4500zc28d61Is4500zc28d61ce

Table of Contents