Instructions For Use - Lanaform Hydrojet Manual

6. INSTRUCTIONS FOR USE

Charging
1 Please charge the product before using
it for the first time. Make sure you use the
charger according to the requirements
below. If you use it abroad, first check
whether the country's voltage and
charger are suitable for this product.
2 Turn off the product first when charging.
Connect the charger to the USB cable
that is included. Insert the charger into
the mains power supply and connect
the product to the USB charger cable.
3 The indicators of the different pro-
grammes will start to flash showing
that charging is in progress. Once the
charging process ends, all the lights will
be lit and permanently on. At this point,
disconnect the product from the USB
cable and disconnect the charger from
the power supply. It's quite normal for the
product and charger to be slightly warm.
4 Approximately two to four hours are
needed to charge the product fully using
the charger that meets the require-
ments. The time may vary depending
on the specific circumstances.
report_p Warning
Do not insert or remove the power cable with
wet hands (this may cause an electric shock
and the product to short-circuit.
Do not use it in places where water is accessible,
such as in a bath or humid environment, in order
to prevent a malfunction or short-circuiting.
You must use the charger that meets the char-
ging requirements.
You should not be too close to the product
during charging; when you leave for a long
period, you must stop charging the device.
Cut off the power immediately when any ano-
malies occur during charging If the charging
cable is damaged or if the plug is loose, stop
charging immediately.
Use and keep the charging cable correctly. Do
not bend it, stretch it, twist it, press it down or
wrap it around the charger.
Instructions for use
Secure the cannula to the device using the
attachment switch.
Open the water reservoir lid, keep the main
unit horizontal and fill the water reservoir
making sure that its temperature does not
exceed 40°C.
Replace the water reservoir lid, making sure
it is locked.
When you use the device for the first time, press
the stop/start switch to set it going.
Choose one of the treatment modes by pressing
the mode selection button.