Mitsubishi Electric Ecodan HUS210FTC4ST Installation Manual page 54

Main Controller
26
Initial Settings
From the Initial settings menu the installer can set the following:
• Date/Time
• Language
• ºC/ºF
• Temp. display
• Contact number
• Time display
• Room sensor settings
1. Use buttons F1 and F2 to move scroll through the menu
list. When the title is highlighted press CONFIRM to edit.
2. Use function buttons appropriate to edit each setting then
press CONFIRM to save the setting.
Room temperature sensor
Please ensure that when using room control mode this sensor is set
to represent whichever Mitsubishi Electric room sensor is to be used,
i.e. 'Main RC' if the main controller is to be used, 'TH1' for fixed wall
mounted sensor or 'Room RC1' if the first wireless controller is to be
used. Time/Zone control is a function which allows up to eight room
sensors to operate on a single hydraulic circuit/zone rotating which
has priority at different times during the day, to activate this function
please go to the following screen.
1. Go to 'room sensor settings' sub menu.
2. When 2-zone temperature control is active or wireless
remote controllers are available, from Room RC
zone select screen, select zone no. to assign to each
remote controller.
3. From Sensor setting screen, select a room sensor to be
used for monitoring the room temperature from Zone 1
and Zone 2 separately.
4. From Sensor setting screen, select Time/Zone to make it
possible to use different room sensors according to the
time schedule set in the Select Time/Zone menu. The
room sensors can be switched up to 4 times within
24 hours.
FTC4 Installation Manual
54
(continued)