Table of Contents
Advertisement
Introduction
1
Important Note to the installer
The Mitsubishi Electric pre-plumbed cylinder is specifically designed to be installed in conjunction with an air source
heat pump. The Mitsubishi Electric pre-plumbed cylinder is available with either an indirect single or twin coil.
Please read these instructions before commencing installation. Unvented cylinders are a controlled service as
defined in the latest edition of the building regulations and should only be fitted by a qualified installer.
The relevant regulations are: England and Wales - Building Regulation G3, Scotland - Technical Standard Section 4,
N Ireland - Building Regulation Part F.
After installation the benchmark log book and included commissioning sheets must be completed and left along
with these instructions, with the householder for future reference. To be installed in accordance to BS6700.
Any water distribution and central heating installation must comply with the relevant recommendation of the current
version of the Regulations and British Standards listed below:
• Building Regulations
• I.E.E Requirements for Electrical Installations (BS 7671)
• Water Regulations
• Manual Handling Operations Regulations
• British Standards BS 6798, BS 5449, BS 5546, BS 5540:1, BS 5440:2, CP331:3, BS 6700,
BS 7593 and BS 7671
• Health and Safety Document No. 635
Only Mitsubishi Electric Accredited Ecodan
Installers (AEI) should install the Ecodan
system.
®
®
Mitsubishi Electric's notes must not be taken as overriding statutory obligations.
When installing unvented hot water systems section G3 of the building regulations should be adhered to.
An annual inspection would also be required to ensure safe, long term operation.
The information in this manual is provided to assist generally in the selection of equipment. The responsibility for
the selection and specification of the equipment must however, remain with the installer and any designers or
consultants concerned with the design and installation.
Please note: Mitsubishi Electric does not therefore accept any responsibility for matters of design, selection or
specification or for the effectiveness of an installation containing one of its products unless specifically requested
to do so at production stage.
All goods are sold subject to the condition of sale
Important Note: Included with the Ecodan
product is the Mitsubishi Electric homeowner guarantee registration
®
card. Please use this card to register within 30 days of commissioning (occupation if new build), and ensure the
homeowner benefits from Mitsubishi Electric homeowner 3 year guarantee for the Ecodan
heat pump boiler.
®
This needs to be completed by both the Accredited Ecodan
Installer and the current homeowner (or signatures
®
of developer if new build). The registration card is free post and is logged by our warranty department. In the
unlikely event of failure of the Ecodan
®
heat pump boiler, return of the card ensures the homeowner's warranty
claim is hassle free. For additional supplies of the 3 year guarantee card please contact the heating department
on 01707 278666.
Please note - if you do not complete and return the registration card the product will only be under warranty of 12 months.
FTC4 Installation Manual
4
Advertisement
Table of Contents
