Related Manuals for Atlas Copco PB 14 D
Summary of Contents for Atlas Copco PB 14 D
- Page 2 Repair instruction No. 171.5/94 PAGE PB 14 D, PB 14 C Dismantling the Remove the catcher housing (8), the anvil assembly rubber ring (7), and the recoil absorber (6) from the anvil housing (2). Expel the anvil (4) together with the recoil ring (5) from the housing (2) by hitting it lightly with a hammer.
- Page 3 Repair instruction No. 171.5/94 PAGE PB 14 D, PB 14 C Dismantling the Press the complete inclined shaft bearing inclined shaft assembly (3) from the taper roller bearing bearing (1) and the gear (2). assembly Turn the inclined shaft bearing assembly...
- Page 4 Repair instruction No. 171.5/94 PAGE PB 14 D, PB 14 C Removing the Unscrew and remove both brush covers carbon brushes (1) from the motor housing. and the electric Push the spring (2) aside with a pair of supplies pliers and pull the carbon brushes (3) from their holders.
-
Page 5: Maintenance
Repair instruction No. 171.5/94 PAGE PB 14 D, PB 14 C Dismantling the Remove the brush lead assembly (5). field case Release the four Allen screws and remove the field case (6) from the bearing housing (1). Tap the field case (6) lightly with a hammer and remove it from the field coil (4). - Page 6 Repair instruction No. 171.5/94 PAGE PB 14 D, PB 14 C At each maintenance the tool must be lubricated as shown in the lubrication chart. After having Lubrication dismantled the entire tool remove the used grease completely and replace by new grease. For assembly a total of 350 g of grease is necessary.
- Page 7 Repair instruction No. 171.5/94 PAGE PB 14 D, PB 14 C Assembly Pressing the Replace the original screws (3) to the outer ring of the armature–facing side of the bearing taper roller housing (2). bearing into the Place the housing onto a press and press bearing housing in the outer ring (1).
- Page 8 Repair instruction No. 171.5/94 PAGE PB 14 D, PB 14 C Assembling the Insert the connection lead into the lower rear handle opening of the rear handle front (7) and assembly lock the switch (6) by depressing the locking button and the pusher at the same time.
- Page 9 Repair instruction No. 171.5/94 PAGE PB 14 D, PB 14 C Fitting the Pull the spring (2) upwards with a hook carbon brushes and insert the carbon brushes (3). Take care that the carbon brushes face the spring with the bevelled side upwards.
- Page 10 Repair instruction No. 171.5/94 PAGE PB 14 D, PB 14 C Mounting the Fit the O–ring (3) to the edn cap (2), fit it to Edn cap the hammer case (4), and secure it with the three screws (1). Assembling the...
- Page 11 Repair instruction No. 171.5/94 PAGE PB 14 D, PB 14 C Assembling the Press the liner (1) into the anvil anvil assembly housing (2). 5 6 7 8 Grease the anvil (4) and replace the O–rings (3) by new ones.