Related Manuals for Atlas Copco PHE 20
Summary of Contents for Atlas Copco PHE 20
- Page 2 Repair Instructions No.163.01/96 PAGE PHE 20 / PHE 26 / PHE 200 Special Tools Allen key Required (Dis-)assembly set 4931 599011 Repair tool set 4931 599016 Important! Before beginning the maintenance work, perform an initial check with a high voltage test according to VDE (see chapter Electrical and Mechanical Test Instructions).
- Page 3 Repair Instructions No.163.01/96 PAGE PHE 20 / PHE 26 / PHE 200 Dismantling the Carefully remove the bearing end plate (9) gear box from the gear box (2) (lever it off with aid of a screwdriver). Remove the gasket (3).
-
Page 4: Maintenance
Repair Instructions No.163.01/96 PAGE PHE 20 / PHE 26 / PHE 200 Dismantling the Remove the disc (1), as well as the locking spindle gear ring, the bearing cover, the disc, the locking ring, the ball bearing, and the seal ring (2). - Page 5 Repair Instructions No.163.01/96 PAGE PHE 20 / PHE 26 / PHE 200 Lubrication Each time maintenance is performed, the machine is to be lubricates as stated in the lubrication plan. After the machine is fully disassembled, completely remove the old grease and replace with new grease.
- Page 6 Repair Instructions No.163.01/96 PAGE PHE 20 / PHE 26 / PHE 200 Assembly Pre-assembling Pre-assemble the reduction gear shaft (1), the reduction the reduction gear wheel (2), the bearing gear shaft cover (3), and the ball bearing (4). Press the pre-assembled components into the bearing end plate (7).
- Page 7 Repair Instructions No.163.01/96 PAGE PHE 20 / PHE 26 / PHE 200 Mounting the Push the spindle gear (6) completely with spindle gear greased balls (5), disc, cup springs (7), ring (8), and locking ring onto the spindle. Push back the ring (8) as well as the cup...
- Page 8 Repair Instructions No.163.01/96 PAGE PHE 20 / PHE 26 / PHE 200 Mounting the Completely assemble the wheel shaft (6) wheel shaft and press the reduction gear flush onto the wheel shaft. Use a new bearing cover (7). Insert the complete wheel shaft into the motor housing (8) and fasten it with screws.