Related Manuals for ElectrIQ EQODHMSS
Summary of Contents for ElectrIQ EQODHMSS
- Page 1 USER MANUAL GAS PATIO HEATER EQODHMSS EQODHMBL WARNING: FOR OUTDOOR USE ONLY OR IN WELL VENTILATED AREAS PLEASE KEEP THE MANUAL FOR FUTURE REFERENCE...
-
Page 2: Table Of Contents
CONTENTS SAFETY PARTS LIST ASSEMBLY SECURING THE BASE OPERATION LEAK TESTING GAS INFORMATION MAINTENANCE STORAGE TROUBLESHOOTING SPECIFICATIONS SUPPORT... -
Page 3: Safety
IMPORTANT SAFETY INFORMATION Please read this user manual before using this heater and keep it safe for future reference. Read the following instructions carefully and be sure your patio heater is properly ⚫ installed, assembled and cared for. Retain the instructions for future reference. Failure to follow these instructions may result in serious bodily injury and/or ⚫... - Page 4 IMPORTANT SAFETY RULES • For use outdoors or in well ventilated areas. Ceiling/Overhang • A well ventilated area must have a minimum of 25% 915mm of the surface area open. • The surface area is the sum of the walls surface. •...
-
Page 5: Parts List
PART LIST PART DESCRIPTION QUANTITY Reflector Panel Reflector Plate Head Assembly Deck Ring Top of Housing (Preassembled) Door (Preassembled) Door Lock (Preassembled) Rear of Housing (Preassembled) Gas Pipe Hose & Regulator Post Base (Preassembled) Wheel Kit PART DESCRIPTION IMAGE QTY. PART DESCRIPTION IMAGE... -
Page 6: Assembly
PATIO HEATER ASSEMBLY Required Tools: Philip Screwdriver and Adjustable Spanner. Leak Detection Solution: One-part detergent and three parts water Before assembly, ensure all packing material and any transit protection is removed. Line up holes on the bracket of the wheel assembly (M) with the corresponding holes on base (L). - Page 7 Attach the Reflector Panels (A) together using the M6 x 8mm Screws (FF), Φ6 Washers (DD) and Cap Nuts (GG). Do not fully tighten at this point. Note: In order to achieve proper alignment of reflector sections, it may be necessary to loosen the preassembled bolts prior to assembly and retighten once complete.
- Page 8 Attach the Reflector Assembly to the Head Assembly (C). Secure with cap nuts (GG) and Φ6 washers (DD). All bolts previously fitted can now be tightened but Do not over tighten! Insert the hose & regulator assembly (I/J) through top of housing (E) and Post (K), tighten gas pipe (I) to head assembly(C).
-
Page 9: Securing The Base
Attach the regulator (J) to the gas cylinder (not included). Place the gas cylinder into the rear of the unit and close the door (F). Note: See instruction Gas requirement and Connecting to a gas cylinder before buying a gas cylinder. -
Page 10: Operation
OPERATING INSTRUCTIONS BEFORE FIRST USE AND AFTER EVERY GAS CYLINDER CHANGE, THE GAS DELIVERY SYSTEM MUST BE PURGED OF AIR BEFORE IGNITING! TO DO THIS, TURN THE CONTROL DIAL ANTI-CLOCKWISE TO THE PILOT SETTING. PRESS THE DIAL IN AND HOLD FOR 1 MINUTE BEFORE ATTEMPTING IGNITION. TO LIGHT THE PILOT ⚫... -
Page 11: Leak Testing
LEAK TESTING NEVER USE A NAKED FLAME TO CHECK FOR LEAKS. NEVER LEAK TEST WHILE SMOKING. The gas connections on this appliance are leak tested at the factory prior to shipment. This appliance needs to be periodically checked for leaks and an immediate check is required if the smell of gas is detected. -
Page 12: Maintenance
MAINTENANCE To enjoy years of outstanding performance from your heater, make sure you perform the following maintenance activities on a regular basis: • Keep exterior surfaces clean. • Use warm soapy water for cleaning. Never use flammable or corrosive cleaning agents. •... -
Page 13: Troubleshooting
TROUBLESHOOTING PROBLEM CONDITION Cylinder valve is closed Open valve Blockage in orifice or pilot tube Clean or replace orifice or pilot tube Open gas line and bleed it (pressing Air in the gas line control dial in) for not more than 1- Pilot won’t light 2 minutes or until you smell gas Low gas pressure... -
Page 14: Specifications
SPECIFICATIONS Product Name Patio Heater Model EQODHMSS, EQODHMBL BE-CY-CH-CZ- BG-HR-CH-CY-DK- FR-ES-GB-GR- EE-FI-GR-HU-IT-IS- CZ-FR-GB- AT-CH-DE- Country Code AT-CH-DE IE-IT-PT-SK-SI- LT-LV-MT-NL-NO-PT- GR-IE-PT SE-SI-SK-RO-TR Category 3+(28-30/37) 3B/P(30) 3P(37) 3B/P(37) 3B/P(50) 3P(50) G30/G31 G30/G31 G30/G31 Pressure(mbar) 28-30 Heat input 12.5KW 12KW 13.5kW 12.5KW Consumption...
Need help?
Do you have a question about the EQODHMSS and is the answer not in the manual?
Questions and answers