Table of Contents
Advertisement
Available languages
Available languages
Configuration
Adjusting the operating mode of the RS232 interface
In the default setting of the extender, you can connect any RS232-compatible device
to the optional RS232 interface of the console module. The RS232 data stream is
transmitted unchanged to the computer module.
For transmitting RS422 signals, you can use two
adapters converts the RS232 interface of the console module and the computer mod-
ule into
interfaces.
RS422
IMPORTANT:
If you want to transmit
you also need to change the operating mode of the RS232 interfaces of both the
console and the computer module.
How to set the operating mode of the RS232 interface:
1. Press
Ctrl+Num
2. Select the row
operating mode of the RS232 interface of the console module (
Select the row
operating mode of the RS232 interface of the computer module (
3. Under
RS232 port mode
RS232
The data stream of an RS232 device is transmitted from the
RS422
The data stream of an RS422 device is transmitted from the
4. Press
F2
to save your settings.
35 · G&D VisionXS-IP-F-DP-UHR
(default) to open the on-screen display.
Console setup
and press
Target setup
and press
press
computer module to the console module (default setting).
computer module to the console module via separately
available
G&D RS232-422 adapters
G&D RS232-422 adapters
RS422
signals, in addition to using adapters,
Enter
if you want to adjust the
Enter
if you want to adjust the
F8
to select on of the following options:
.
. Each of the
CON
).
CPU
).
Advertisement
Chapters
Table of Contents
