Onean Carver User Manual page 17

1. Attach the leash right below the knee of the front leg, as shown on the
drawing below.
2. Once the rider is
place the security magnet key on the board.
Magnetic Key
Connector
Magnetic Key
The magentic key is a security mechanism, the jet will not activate if this
key is not properly placed.
3. In case of fall, the magnetic key will detatch, stopping the jet. Once the
rider is back on the board ready to continue its use, the magnetic key
should be properly placed again.
ready to use the board,
The board has various security mechanisms that stop it automatically in case
of:
• Engine overheat.
• Battery overheat.
• Loss of communication between the controller and board.
• Tightening of the jet when starting or blockage of the turbine due to an
external object.
• Magnetic key disconnection. In case of fall, it will automatically disconnect.
• In case of fall, or if the controller is submerged, the jet will stop as a
security measure.
If any of the previous cases happes during use, the jet will automatically stop.
This security block will remain until the above causes are solved.
In order to reactivate the board, the security magnet must be disconnected
and reconnected.
CARVER USER'S MANUAL
17