Car Operation - Kaiser Baas R1 User Manual

INSTALLATION
5. Insert the Car Charger Adaptor into the car's charger socket. Insert one end of the
Car Charger Cable into the DC In jack on the Car Camera and the other end into one
of the USB ports in the Car Charger Adaptor.
Notes:
• When the unit is connected to the car's charger, the car will charge the Car Camera
as long as the ignition is on.
• Your device can be powered either from its internal battery, which is charged via
USB cable (included) connected to your home computer as shown on page 22 or by
connecting it to your vehicle's power source as shown in the next section.
If you choose to use the internal battery, charge the device for at least five hours
before first use.
• This unit uses an internal ball to determine the positioning and will rattle when it is
moved. This is normal.
12

CAR OPERATION

1. When the unit is connected as previously instructed and the car ignition is turned
on, it will power up and start recording automatically in approximately 5 seconds
(the red Record icon "•" will blink in the display).
The unit's recordings will be separated into segments depending on the time set,
read page 21 for instructions.
2. To zoom in, press the 3 button. To zoom out, press the 4 button.
3. To manually stop recording, press the • /OK button.
4. You can take pictures instead of video by pressing the Mode button once while in
the Stop mode; the icon will appear in the display. Then press the • /OK button
to take a picture.
5. When the car ignition is turned off, the unit will stop recording after 3 seconds.
Press the Power button to turn the unit off.
1 3
13