Product Clearances - Monogram ZDWI240 Installation Instructions Manual

For Models ZDWR240 and ZDBR240 with Stainless Steel Door Panels and Handles
THE INSTALLATION SPACE
For a flush installation
Install a 1/4"-wide filler strip on the hinge side. The filler
strip will act as a spacer between the door case and
adjacent cabinets and will prevent interference with the
cabinet door swing. Recess the filler strip 1-5/8" back
from the front face of the refrigerator, or even with the
front edge of the product case (behind the gasket). The
width of the opening must be 24" (including the 1/4" filler
strip).
Installation
Filler panel or cleat to be set
CABINET
back even with front of case.
Front edge of product case
Front face
For a standard installation
The product must be installed so that the product front
will project forward of the adjacent cabinets by the
dimensions T or U according to the model in the chart.
This position will allow a full door swing and prevent
interference with adjacent cabinetry. The opening
between cabinets must be a minimum of dimension K.
Installation
CABINET
Front edge of product case
T,U
Front face
In a standard installation, the product
will project forward of adjacent cabinets.
See T,U.
Product Extended Dimension
T ZDWI240 & ZDBi240
U ZDWR240 & ZDBR240
31-1000646
Design Guide
for Flush and Standard Installation
Flush
1/4"
CABINET
110°
120°
Standard
CABINET
110°
120°
1-3/4"
2"

PRODUCT CLEARANCES

The stainless steel wine chiller, wine reserve and
beverage center is factory set for a 110° door swing.
Models that accept custom panels have a 95° door
swing.
When installed in a corner:
door swing and to allow racks to slide out.
a full 110° door swing. (Models ZDWI240WII and
ZDBI240WII have a 95° door swing.)
10" Minimum
to Wall
110*
*95 Door Swing on Custom Frame Models
NOTE: Custom handle clearances may vary, depending
on custom handle depth.
• The door swing is reversible on all models. If desired,
change the door swing before installation or before
installing the custom frame panel.
Choose the location:
• These products may be closed in on the top and
three sides as long as the front is unobstructed for air
circulation and proper access to the door.
• Do not install these products where the temperature
will go below 55°F (13°C) or above 100°F (37°C).
• Do not install where it will be subject to direct sunlight,
heat or moisture.
• Do not install where it will be subject to direct sunlight,
heat or moisture.
• These products are not designed to be stacked one
over the other.
Black or Stainless Steel Toekick Options
• These products are shipped with a black toekick
installed. An optional stainless steel toekick is also
supplied with each product. For shipping purposes,
the stainless steel toekick is secured to the back of the
unit.
90° Door Swing
B
R
F
90
4" Minimum
to Wall
7