Table Of Contents; Design Guide; Tools Required; Parts Supplied - Monogram ZDWI240 Installation Instructions Manual

CONTENTS
Safety Information ...................................................2, 3
Design Guide
Tools Required ..............................................................4
Parts Supplied ...............................................................4
Refrigerator Location .....................................................4
Staining Wood Drawer Fronts ......................................4
Installing Custom Frame Panel ....................................4
Caring for Your Stainless Steel .....................................4
The Installation Space .......................................... 5-6
Side-by-Side Installation ......................................... 6
Product Clearances ............................................. 7, 8
Installation Instructions
Step 1, Remove Packaging ..................................... 9
Step 2, Reverse Door Swing ............................. 9, 10
Step 3, Leveling ..................................................... 10
Step 4, Connect Power.......................................... 10
Step 5, Slide Product into Cutout .......................... 10
Step 6, Set Temperature Controls ......................... 10
Custom Frame Panel Models .................................11

TOOLS REQUIRED

• #2 Phillips screwdriver
• Adjustable wrench

PARTS SUPPLIED

• Hardware for changing door swing
• Optional stainless steel toekick with screws and
spacers
• Left and right side hinge covers
• Top screw hole cover

REFRIGERATOR LOCATION

• Do not install the refrigerator where the temperature
will go below 55°F (12.7°C) because it will not run
often enough to maintain proper temperatures.
• Do not install the refrigerator where the tempera-
ture will go above 100°F (37°C) because it will not
perform properly.
• Do not install the refrigerator in a location exposed to
water (rain, etc.) or direct sunlight.
• Install it on a floor strong enough to support it fully
loaded.
4

Design Guide

STAINING WOOD DRAWER
FRONTS
use, oil from hands may accumulate and stain the wood.
• The drawer fronts may be stained and sealed to match
adjacent cabinetry. The tinted glass will make the
stained wood appear darker. A true color match can be
seen only when the door is opened.
• Apply the stain and sealer according to the manufac-
turer's instructions. To avoid unpleasant odor, keep the
door open to ventilate and allow the stain/sealer to dry
completely before using the product.
INSTALLING THE CUSTOM FRAME
PANEL
Go to page 6 for custom frame panel size, depending on
your cabinet size and style.
• Install a custom handle of your choice onto the custom
panel before the panel is secured to the door.
• The custom panel should be installed before sliding the
product into the installation location.
WARNING
Cabinet edges along stamp/cut-out areas may be sharp.
Avoid placing hands, fingers, or other appendages near
these areas. Failure to do so can result in cuts.
AVERTISSEMENT
Les bords de la caisse et les zones comportant un code
d'identication ou des découpes peuvent être tranchants.
Garder les mains, les doigts ou autres appendices éloignés
de ces zones. Le non-respect de cette instruction peut causer
des coupures.
CARING FOR YOUR STAINLESS
STEEL
• Before installation or first use, we strongly advise that
you polish the stainless steel exterior and handle with
a commercially available stainless steel cleaner such
as Stainless Steel Magic.™ To preserve and protect
the fine finish, we also strongly advise that you apply
stainless steel cleaner monthly.
CUT HAZARD
Risque de coupure
31-1000646