Hinkley HOVER Instruction Manual page 13

INSTALLING THE LED ASSEMBLY AND GLASS SHADE
Adapter Plate
Light Wires
Fig. 1
NOTE: Be sure the power is off before installing.
1
Remove one of the three screws on the mounting hub
located on the fan motor. Loosen the other 2 screws. (Do not
remove) (Fig. 1)
2
Pass the light wires through the center hole of the adapter
plate.
3
Place the key holes on the adapter plate over the 2 screws
previously loosened, turn the adapter plate until it locks in
place at the narrow section of the key holes. Secure by
tightening the 2 screws previously loosened and the one
previously removed.
4 Remove one of the three screws on the adapter plate
located on the fan motor. Loosen the other 2 screws. (Do not
remove) (Fig. 2)
Mounting Hub
(bottom of motor)
Screws
5
Wire connectors
LED
Assembly
Glass shade
Fig. 2
While holding the LED assembly under your fan, make the
5
polarized plug connections: (Fig. 2)
- Red to white
- Black to black
Tuck connections neatly into adapter plate. Place the key
6
holes on the LED assembly over the 2 screws previously
loosened, turn the LED assembly until it locks in place at the
narrow section of the key holes. Secure by tightening the 2
screws previously loosened and the one previously removed.
7 Raise the glass shade against the LED assembly and turn
clockwise until snug, DO NOT OVERTIGHTEN.
8
Restore power and your LED assembly is ready for operation.
Adapter Plate
Screws
©2019 Hinkley Lighting, Inc. | hinkley.com | 11