Infinity Classia Series Service Manual page 8

PSW310W subwoofer Classia Series
S C
YSTEM ONNECTIONS
Choose either Wireless or Wired connection, then follow the appropriate instructions.
WIRELESS
Connecting the Subwoofer for Wireless Applications
DC18V
Step 1.
Connect a subwoofer cable from the subwoofer or LFE output of
your receiver to the Sub In H on the transmitter.
Step 2.
Plug the transmitter module into the wall outlet, and connect the
included power supply and power cord to the transmitter F . Make
sure the Transmitter Antenna E is extended upward.
Step 3.
Set the ID code on the transmitter and subwoofer
the same position, as described on page 4. When connected properly,
the LED ¢ on the rear of the subwoofer will be orange.
Step 4.
Set the Low-Pass Selector ∞ to the "Off" position.
NOTE: Some receivers have two subwoofer outputs. In that case, use
either one of the connectors.
INFINITY CLASSIA PSW310W (120V)
ID
CODE
Sub In
1 2 3 4
G and §
( )
to
WIRED
Connecting the Subwoofer for Wired Applications
If you have a Dolby ® Digital or DTS
a low-frequency effects (LFE) or subwoofer output:
Level
Wireless
O O ff ff
ID Code
Low-Pass Low-Pass
R
L LFE
Sub In
If your receiver/processor does not contain a Dolby Digital
or DTS processor but has subwoofer outputs:
NOTE: If your receiver/processor has only one sub out, you
may use either the L or R input.
7
® receiver/processor with
Crossover
[Hz]
O O n n
Green: Sub On
Red: Standby
Orange: Sub On and
Wireless Link Active
Line In
Level
Crossover
[Hz]
Wireless
O ff O n
ID Code
Low-Pass
Green: Sub On
Red: Standby
Orange: Sub On and
Wireless Link Active
L R LFE
Sub In Line In