Innova GetGo SF02M3W:4+7 Owner's Manual page 14

SYNCHRONIZING TWO BEDS
The bed base is designed to allow two twin XL bases to become an Eastern King base
and two Split-Cal-King bases to become a Cal-King base. You can use the same
Remote to control two side-by-side beds bases by following Step 6 on the installation
guide to synchronize one Remote with the two Control Boxes of the two units.
• After base A is paired by following the directions in Step 6, plug in base B and
wait for the base to return to flat. You will hear a beep, and it will enter the
pairing state for 10 seconds. (If not paired within 10 seconds, please press the
SYNC button to enter the pairing mode on base B.)
• Using the same remote, simultaneously press the FOOT UP and FOOT DOWN
button for 3-5 seconds.
• You will hear a beep to signal pairing is complete.
USING BOTH REMOTES ON THE SAME BED
• Sync the Remote A with the 2 control boxes by following the above directions for
Synchronizing Two Beds.
• Then sync the Remote B by following the above directions for Synchronizing Two
Beds.
• Now both Wireless Remotes will be able to control both beds.
DESYNCHRONIZING TWO REMOTES
• To remove syncing on one remote, press the SYNC button for 3-5 seconds. You will
hear a beep to confirm that the base is ready to sync. To pair again, refer to Step 6
to sync base A with remote A and base B with Remote B, individually.
14