What You Will Need To Set Up Your Camera; Installing The Batteries; Installing The Sd Card; Camera Button Control Diagram - Covert WC20-A Instruction Manual

What You Will Need to Set Up Your Camera

Installing the Batteries

Your WC20 can function short term on 6 AA batteries. To function on 6 batteries, one full side of the battery case must
have all 6 batteries installed, either the front or back of the case. Improved battery life on 8 AA, but we suggest you use
12 AA batteries to get the most out of your camera's battery life.
Install batteries by sliding the top battery into the sleeve, then depressing the spring with the other battery and
snapping down in place. Pay attention to the (+) of (-) molded into each sleeve to determine if you insert the positive or
negative end into the sleeve first. The negative battery terminal (the flat end) always contacts the spring.

Installing the SD Card

Now that you have activated your plan, you will need to install an SD card in the left side of the front case. We
recommend a Covert SD card. Other SD cards may work, but also use an encryption that may not be compatible with
your camera. See below for card orientation. Push the card in until it clicks and release. To remove, repeat that
process, the card will pop out enough to remove. You can use any SD card up to 32 GB.

Camera Button Control Diagram

Set-Up Screen
QR Code for Registration.
(Do not scan code in manual,
scan the code on your device)
*Will work with other cards
ON/OFF Switch
Menu button
and controls.
4