Setting The Temperature; Temperature Display - Miele KWT 6321 UG Operating And Installation Instructions

Temperature and air quality
Isolator plate for thermal separation
The appliance has a fixed isolator plate
which divides the cabinet into two
different zones. This enables you to
store different types of wine (e.g. red
and white) at the same time.

Setting the temperature

You can set the respective
temperatures using the two sensors
below the temperature displays.
Touch the
Y sensor: the temperature gets warmer
X sensor: the temperature gets cooler
The temperature range being set will
flash in the display as you do this.
When you touch the sensors, you will
see the following changes in the
respective temperature display:
– Touching a sensor once: the last
temperature selected flashes.
– Each subsequent touch of a sensor:
The temperature is adjusted in 1 °C
steps.
– Keeping your finger on the sensor:
changes the temperature
continuously.
Approximately 5 seconds after you
release the sensor, the actual
temperature in the respective zone will
be displayed.
20
The two temperature zones are cooled
alternately which means that,
depending on the amount of wine being
stored, it may take a few hours before
the set temperatures are reached and
the temperature displays have adjusted
accordingly. If, after some time, the
temperature in either zone is too warm
or too cold, set the temperature again.
Temperature range
The temperature in both zones can be
set to anywhere between 5 and 20 °C.

Temperature display

In normal operation the temperature
displays in the control panel show the
actual temperature in the appliance.
The temperature display will flash if
– a different temperature is being set,
– the temperature in one zone deviates
from the set temperature by more
than 5 °C.