Related Manuals for Cleanburn Sonderskoven Inset 5
Summary of Contents for Cleanburn Sonderskoven Inset 5
- Page 1 Sønderskoven Inset 5 Installation and Operating Instructions JINHCN05 RevE 22/07/14...
- Page 2 Inset 5 Ø Technical Specification SØNDERSKOVEN INSET 5 Cleanburn Stoves, Unit 6, Old Mill Industrial Estate, EX5 4RJ BS/EN 13229 UKAS# 0692 Stove Mass: 100 kg NOMINAL OUTPUT: 4.9 KW CO Emission at 13% O : 0.19% Mean Flue Gas Temperature: 292°C EFFICIENCY: 77.1%...
-
Page 3: General Guidance
OMPETENT ERSONS CHEME manufactured in accordance with BS8423 – Cleanburn Stoves recommend that this stove is Fireguards for use with solid fuel appliances. installed by a member of an accredited competent persons scheme e.g. HETAS. It is possible to fire the stove beyond its design capacity. -
Page 4: Adverse Weather
If you have any doubts about the suitability of your before installing this appliance. Cleanburn Stoves chimney, consult your local dealer/stockist. Ltd cannot be held responsible for any fault arising through incorrect use or installation. -
Page 5: Flue Draught
the sides, and should be in accordance with the Flue Draught current building regulations. If the flue draught exceeds the recommended maximum, a draught stabiliser must be fitted so In all instances the hearth and fireplace recess that the rate of burning can be controlled and to should be made of non-combustible material. -
Page 6: Appliance Dimensions
PPLIANCE IMENSIONS Remove the catch bar / front plate by lifting the right-hand side until it will clear the opening and remove. Remove the grate bars by lifting them away from the cam bar and pulling forward out of Removing Internal Components the rear grate support. - Page 7 5. Remove the cam bar by firstly sliding it to the 8. Remove the ash barrier by sliding out of the right until the left hand end is clear of the hole. stove. 9. Remove the baffle by lifting and tilting one edge so it can be lowered into the firebox and removed.
-
Page 8: Installing The Stove
11. Remove the upper rear brick by lowering it 14. Remove the lower rear brick by tilting the top down into the firebox and out. edge into the firebox and lifting out. Installing the Stove 12. The second upper side brick can now be removed. -
Page 9: Commissioning And Handover
WARNING – This appliance will be hot when in operation and due care should be taken. The supplied operating tool or gloves may be used to open the door and operate the air controls. EROSOLS Do not use an aerosol spray on or near the stove when it is alight. -
Page 10: Reduced Combustion
OCOMOTIVE RATE the fuel and stove to cool before attempting to Your Cleanburn Stove is fitted with a locomotive relight the fire. type grate. So that de-ashing can be carried out cleanly and easily, it is riddled from the outside of N.B. -
Page 11: Recommended Fuels
ECOMMENDED UELS have been "authorised" in Regulations and that Cleanburn Stoves recommend that wood logs are appliances used to burn solid fuel in those areas burnt in this appliance. (other than "authorised" fuels) have been... - Page 12 Rope - Check the rope around the door. If rope is such as during the spring and summer months, a becoming detached, use Cleanburn Stoves rope competent person should check the chimney for glue to reattach it. If the rope is in a poor potential obstructions before lighting the stove i.e.
-
Page 13: Troubleshooting
Primary Air Valve – The primary air valve can be To install the primary air valve, slide the valve in removed from the stove. To do this first remove centrally until you hear the locating pin click into the Ashpan, Fuel Retainer, Grate Bars and Cam Bar place. -
Page 14: Spares Information
Spares Information INGLE PARES SINGLE DOOR HCE09/008 DOOR GLASS HCE09/102 DOOR CATCH ASSEMBLY HCE09/ARRT/043 ROPE SEALING KIT SCPCB900SDRSK-REVC GLASS CLIP HHR08/046 GLASS GASKET HCE09/101 GLASS CLIP SCREW FSJM05008SS JINHCN05 RevE 22/07/14... -
Page 15: Right Hand Door
OUBLE PARES LEFT HAND DOOR DOOR GLASS HCE09/010 HCE09/031 GLASS CLIP GLASS GASKET HHR08/046 HCE09/030 GLASS CLIP SCREW FSJM05008SS IGHT ROPE SEALING KIT SCPCB900DDRSK RIGHT HAND DOOR GLASS CLIP SCREW HCE09/009 FSJM05008SS GLASS CLIP HHR08/046 DOOR HANDLE HCE09/033 GLASS GASKET HCE09/030 DOOR CATCH ASSEMBLY... - Page 16 SSEMBLY PARES SLIDER KNOB TURBO BARS HCE06/059 HCN05/ARRT/022 A&B BAFFLE HCN05/022 UPPER SIDE BRICK HCN05/024 HINGE UPPER REAR BRICK HH06/050 HCN05/026 HINGE PIN LOWER REAR BRICK FRRE08-1.75 HCN05/025 REAR GRATE SUPPORT LOWER SIDE BRICK HCN05/035 HCN05/023 FUEL RETAINER GRATE BARS HCN05/ARRT/030 SIDE: CNN05/004 A&B UPPER: CNS04/013...
Need help?
Do you have a question about the Sonderskoven Inset 5 and is the answer not in the manual?
Questions and answers