Advertisement
Align the top middle cover to the chassis.
2.
Figure 4 Reinstalling the Top Middle Cover
Drives
The server supports 9 to 12 drive bays --- 8 drive bays for 3.5-inch hard disk drives and 1 drive bay
for optical disc drive; or 12 drive bays for 3.5-inch hard disk drives.
Cable Management
Always follow good cable management practices when working inside the computer.
•
Keep cables away from major heat sources like heat sinks.
•
Do not jam cables on top of expansion cards or memory modules. Printed circuit cards are not
designed to withstand excessive pressure.
•
Keep cables clear of sliding or moveable parts to prevent cutting or crimping.
•
When folding a flat ribbon cable, never fold to a sharp crease. Sharp creases may damage the
wires.
•
Some flat ribbon cables come pre-folded. Never change the folds on these cables.
•
Do not sharply bend any cable. A sharp bend can break the internal wires.
•
Never bend a SATA data cable tighter than a 30 mm (1.18 inch) radius.
•
Never crease a SATA data cable.
•
Do not rely on components like the drive cage, power supply, or system cover in order not to
push cables down into the chassis.
Removing power supply power cables from the system board connectors follow below steps:
Squeeze on the top of the retaining latch attached to the cable end of the connector.
1.
Grasp the cable end of the connector and pull it straight up.
2.
CAUTION: Always pull the connector-NEVER pull on the cable. Pulling on the cable could damage
the cable and result in a failed power supply.
All manuals and user guides at all-guides.com
Contents 32
Advertisement
