Prilux Ebro LED Manual page 3

Ebro LED
103
ELECTRICAL CHARACTERISTICS
Voltage
DEGREE OF PROTECTION
Electrical isolation
Degree of waterlightness
WARNING
BEFORE INSTALLING THIS PRODUCT, PLEASE READ THE
INSTRUCTIONS CAREFULLY AND STORE THEM IN A
SAFE PLACE.
THE INSTALLATION SHOULD BE CARRIED OUT BY TRAI-
NED STAFF.
INCORRECT HANDLING OF THE PARTS OR THE LIGHT
FIXTURE ITSELF MAY IMPAIR THE PROPER PERFOR-
MANCE OF THIS PRODUCT. IN THIS CASE, THE MANU-
FACTURER GUARANTEE SHALL BE DEEMED VOID.
THE MANUFACTURER GUARANTEE SHALL BE DEEMED
VOID: IF THE INSTALLATION IS NOT PERFORMED IN
ACCORDANCE WITH THE SPANISH LOW VOLTAGE
ELECTROTECHNICAL REGULATION 2002 (REBT 2002).
OBSERVE PRECAUTIONS
HANDLING
SENSITIVE DEVICES.
1/2 3/4
noviembre 2020
noviembre 2020
241
230V
IP20
ATTENTION!!!
FOR
ELECTROSTATIC
PRECAUTIONS:
• Keep out of reach of children.
• Do not immerse this product in water or handle it with wet hands.
• Do not use gloves or any plastic material.
• Do not hit the product.
• Do not install the product where there are heat sources or
moisture concentrations.
• Do not handle the product while it is in operation and let it cool
before touching it with your hands.
• Keep a minimum distance of 1m with the surface or object to be
illuminated.
• Not valid for use in bathrooms.
• The product must not be covered by thermal insulation material
in any case.
• If the product is damaged, replace it immediately with a new
one.
• Disconnect the power before installing the product.
• Handle the luminaire by holding the body, never pressing the
diffuser as it could sink and damage the light source (LED).
• This luminaire contains components sensitive to static electricity
and a discharge on it could destroy or damage its components.
ASSEMBLY INSTRUCTIONS:
1. Drill a hole in the mounting surface of 220x132mm (FIG 2).
2. Disconnect the power.
3. Remove the screws and remove the driver cover. Loosen the
connector screws, insert the power cable to L and N as ap-
propriate, keeping in mind that the blue wire is the neutral wire
(N) and the brown wire is the wire of the phase (L). Tighten the
connector screws once connected. Make sure the connection is
correct and there is no bare copper wire. Fit the driver cover and
tighten the screws (FIG 1).
4. Place the driver inside the installation shaft (FIG 3).
5. Fold the fixing springs and insert the luminaire into the ceiling (FIG
3).
6. Reset the current.
REPLACEMENT OF THE LAMP:
• Lamp not replaceable.
CHANGE OF THE EQUIPMENT:
1. Disconnect the power.
2. Remove the luminaire.
3. Replace the equipment with a new one. For the connection of
the equipment follow the previous instructions (FIG 1).
4. Install the luminaire back into the installation space (FIG 3).
5. Reset the current.