Black & Decker Dustbuster NV1200AV Manual page 6

ENGLISH
5. Brush tool
6. Small Crevice tool
7. Large Crevice tool
8. Hose
9. Right angle brush
10. Hose connector
Assembly
Mounting accessories (fi g. B)
To fi t an accessory proceed as follows:
♦
Insert the appropriate accessory into the front
of the appliance
Use
Connecting to the vehicle's power supply
♦
Make sure that the appliance is switched off.
♦
Remove the cigarette lighter from it's socket.
♦
Plug the connector (4) into the cigarette lighter
socket.
Switching on and off (fi g. A)
♦
To switch on, slide the on/off switch (1)
forward.
♦
To switch off, slide the on/off switch (1)
backward
The appliance can be used for periods of up to 30
minutes without noticeably affecting the power of
a normally charged car battery in good condition.
Warning! Extended use will drain the battery
power. Do not run the vehicle's engine while
cleaning as this can shorten the life of the
appliance.
Cleaning and maintenance
Cleaning the dust bowl and fi lters
(fi g. C & D)
Your BLACK+DECKER tool has been designed to
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper care and regular cleaning.
♦
Press the release button (2) and remove the
dust bowl (3).
♦
Empty the dust bowl.
♦
Remove the pre-fi lter (11) by twisting
clockwise.
♦
Wash the fi lter in warm soapy water. The bowl
can be washed if necessary. Do not immerse
the appliance in water.
♦
Make sure the dust bowl and fi lters are dry.
♦
Refi t the fi lters (11) onto the appliance twisting
them counterclockwise until they lock into
place.
6
♦
Refi t the dust bowl onto the appliance. Make
sure the dust bowl clicks into place.
Warning! Before performing any maintenance or
cleaning on the appliance, unplug the appliance.
Warning! Never use the appliance without
the fi lters. Optimum dust collection will only be
achieved with clean fi lters and an empty dust
bowl.
Replacing the fi lters
The fi lters should be replaced every 6 to 9 months
and whenever worn or damaged. Replacement
fi lters are available from your BLACK+DECKER
dealer (cat. no VF30):
♦
Remove the old fi lters as described above.
♦
Fit the new fi lters as described above.
Protecting the environment
Separate collection. This product must
not be disposed of with normal household
waste.
Should you fi nd one day that your
BLACK+DECKER product needs replacement, or
if it is of no further use to you, do not dispose of it
with household waste. Make this product available
for separate collection.
Separate collection of used products and
packaging allows materials to be recycled
and used again. Re-use of recycled
materials helps prevent environmental
pollution and reduces the demand for raw
materials.
Local regulations may provide for separate
collection of electrical products from the
household, at municipal waste sites or by the
retailer when you purchase a new product.
BLACK+DECKER provides a facility for the
collection and recycling of BLACK+DECKER
products once they have reached the end of their
working life. To take advantage of this service
please return your product to any authorised
repair agent who will collect them on our behalf.
You can check the location of your nearest
authorised repair agent by contacting your local
BLACK+DECKER offi ce at the address indicated
in this manual. Alternatively, a list of authorised
BLACK+DECKER repair agents and full details of
our after-sales service and contacts are available
on the Internet at: www.2helpU.com.
Autogoods "130"