Before Using The Unit - Vitek VT-1451 ST Manual Instruction

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
ENGLISH
For children safety reasons do not leave
polyethylene bags used as a packaging
unattended.
Attention! Do not allow children to play with
polyethylene bags or packaging film. Danger
of suffocation!
Do not allow children under 8 years of age to
touch the body of the motor unit, the power
cord or the power plug during the unit oper-
ation.
Do not allow children under 8 years of age to
use the unit as a toy.
Close supervision is necessary when chil-
dren under 8 years of age or disabled per-
sons are near the operating unit.
This unit is not intended for usage by chil-
dren under 8 years of age.
Children aged 8 and over as well as disabled
persons can use the unit only under supervi-
sion of a person who is responsible for their
safety if they are given all the necessary
and understandable instructions concern-
ing the safe usage of the unit and informa-
tion about danger that can be caused by its
improper usage.
To avoid damages, transport the unit in orig-
inal package only.
To avoid risk of electric shock or fire, do not
immerse the unit body, the power cord and
the power plug into water or any other liq-
uids. If the unit is dropped into water:
do not touch the water;
unplug the unit immediately, only after
that you may take the unit out of water;
apply to the authorized service center for
testing or repairing the unit.
Keep the unit out of reach of children under
8 years of age.
Do not repair the unit by yourself. Do not
disassemble the unit by yourself, if any mal-
function is detected or after it was dropped,
unplug the unit and apply to any authorized
service center from the contact address list
given in the warranty book and on the web-
site www.vitek.ru.
THE UNIT IS INTENDED FOR HOUSEHOLD
USAGE ONLY

BEFORE USING THE UNIT

After unit transportation or storage at
low temperature keep it for at least two
VT-1451.indd 4
hours at room temperature before switch-
ing on.
Wash the attachments that will contact
products with warm water and a neutral
detergent and dry them thoroughly before
use.
Wipe the motor unit (2), whisk gear (9) and
geared lid (8) with a soft slightly damp cloth
and then wipe them dry.
Attention!
Do not immerse the motor unit (2), the
whisk gear (9), the geared lid (8), the
power cord and the power plug into
water or any other liquids.
Do not put the attachments and bowls in
a dishwashing machine.
Continuous operation time
Continuous operation time with attachments
should not exceed 1 minute and should not
exceed 15 seconds when chopping hard
products. Make at least a two-minute break
between operation cycles.
USING THE BLENDER ATTACHMENT
WARNING: Before assembling and install-
ing attachments, make sure that the power
plug is not inserted into the mains socket.
Insert the blender attachment (1) into the
motor unit (2), having preliminary matched
the corresponding marks, and turn the
blender attachment (1) clockwise until
bumping.
Insert the power plug into the mains socket.
Immerse the blender attachment (1) into the
bowl with food that you want to chop or mix.
Attention! While processing products keep
the unit vertically.
To switch the unit on, press and hold down
the on/off button «I» (4). Set the required
operation speed with the control knob (5).
Use this operation mode for mixing liquid
products.
If you press and hold down the turbo mode
on button «TURBO» (3), the unit will operate
at maximum rotation speed. Use this opera-
tion mode for combined processing of liquid
and solid products.
Note:
Products should be put into the bowl before
the unit is switched on. The amount of prod-
ucts to be processed should not exceed 2/3
4
07.09.2015 11:36:50

Advertisement

Table of Contents
loading

Table of Contents