Supplied Accessories; Making The Connections; Preparing The Remote Control - Panasonic SC-HC300 Owner's Manual

CAUTION: TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE SCREWS.
NO USER-SERVICEABLE PARTS
INSIDE.
REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.
The lightning flash with arrowhead
symbol, within an equilateral triangle, is
intended to alert the user to the presence
of uninsulated "dangerous voltage" within
the product's enclosure that may be of
sufficient magnitude to constitute a risk of
electric shock to persons.
The exclamation point within an
equilateral triangle is intended to alert the
user to the presence of important
operating and maintenance (servicing)
instructions in the literature accompanying
the appliance.

Supplied accessories

Check and identify the supplied accessories.
Product numbers correct as of April 2018. This may be
subject to change.
To order accessories, call the dealer from whom you have
made your purchase.

1 AC power supply cord
(K2CB2YY00065)

1 FM indoor antenna
(RSAX0002)

1 Remote control
(N2QAYB000944)

1 Remote control battery
The included Canadian French label sheet corresponds to
the English printing on the top and rear of the unit.
The symbols on this product (including the
accessories) represent the following:
AC
DC
Class II equipment (The construction of the
product is double-insulated.)
ON
!
Standby
`
4

Making the connections

Connect the AC power supply cord only after all the
other connections have been made.
1
Connect the FM indoor antenna.
2
Connect the AC power supply cord.
To household
AC outlet
Do not use any other AC power supply cord except
the supplied one.
Conserving power
The system consumes a small amount of power
( 16) even when it is in standby mode. Disconnect
the power supply if you do not use the system.
Some settings will be lost after you disconnect the
system. You have to set them again.
Note:
•
These speakers do not have magnetic shielding. Do not put
them near TVs, PCs or other equipment easily influenced by
magnetism.
•
Tape the antenna to a wall with the least amount of
interference.
•
Use an outdoor antenna (not supplied) if reception is poor.

Preparing the remote control

Use alkaline or manganese battery.
Install the battery so that the poles (+ and –) align with
those in the remote control.
Adhesive tape
(not supplied)