Bucking Spike; Fueling - EMAK MT3600 Operator's Instruction Manual

en
18
OPERATION

Bucking Spike

WARNING: Your chain saw may be fitted with an
optional bucking spike (G, Fig. 34). The bucking
spike is very sharp and can cause injury. Be extre-
34
mely careful when working near the bucking spike.

Fueling

(Do Not Smoke!)
This product is powered by a 2-cycle engine and requires pre-
mixing gasoline and 2-cycle oil. Pre-mix unleaded gasoline and 2-
cycle engine oil in a clean container approved for gasoline (Fig.
35).
35 RECOMMENDED FUEL: THIS ENGINE IS CERTIFIED TO OPE-
RATE ON UNLEADED GASOLINE INTENDED FOR AUTOMOTI-
VE USE WITH AN OCTANE RATING OF 89 ([R + M] / 2) OR
HIGHER (Fig. 36).
Mix 2-Cycle Engine Oil with gasoline according to the instructions
on the package. If 2-Cycle Engine Oil is not available, use a high
quality 2-cycle engine oil for correct mixing proportion see table
below (Fig. 37).
CAUTION: DO NOT USE AUTOMOTIVE OIL OR
2-CYCLE OUTBOARD OIL.
36
CAUTION: Never use a fuel with an alcohol percentage
higher than 10%; gasohol up to 10% alcohol or E10
fuel are acceptable.
When using an Oxygenated Gasoline a good practice of Fuel
Management is necessary.
Gasoline Oxygenated with alcohol readily takes/up water when it
is present; the water may be condensed out of humid air or be a
contaminant in the fuel system, including tank.
CAUTION:
- Match your fuel purchases to your consumption;
37
don't buy more than you will use in one or two
months;
- Store gasoline in a tightly-closed container in a
cool, dry place.
The use of Oxygenated Gasoline may cause the occurrence of
vapor-lock easier.