Table of Contents
Advertisement
NL Set up and connect
Loosen and remove the screws of
3.
the horizontal transport
reinforcement with a T20
screwdriver.
Remove the transport
4.
reinforcement.
4.6 Connecting device
Connect water supply hose
Connect the water supply hose to
1.
the appliance.
16
Connect the water inlet hose to the
2.
tap (26.4 mm = 3/4").
Open the tap carefully and check
3.
that the connections are tight.
Water drainage connection types
The information will help you connect this
appliance to the water outlet.
PAY ATTENTION!
When draining, the water drain hose is
under pressure and can come loose
from the installed connection position.
▶
Secure the water drain hose against
unintentional disconnection.
Remark: Observe the pumping
heights.
The maximum pumping height bed
washbasin
The connection position
tie with a
hose clamp
(24-40 mm) bore
gene.
the water drainage
feeding hose with
a bend
fixate and
gene.
Advertisement
Table of Contents
