Table of Contents
Advertisement
NL Troubleshooting
Malfunction
In the compartment
there is residual water.
Vibration and movement
of the appliance
during the spin
run.
Drum is spinning, er
no water flows into
the appliance.
strong foam
ming.
High spin speed
rental is not
reached.
Program centrifugal
run does not start.
44
Cause and Troubleshooting
Insert in compartment is hidden.
→ "Cleaning the detergent drawer",
▶
Page 34
The appliance is not leveled properly.
Adjusting the device
▶
Device feet are not fixed.
Secure the device feet. Adjusting the device
▶
Transport protections have not been removed.
Remove transport locks
▶
Load recognition is active.
No error, no action necessary.
▶
Remark: The load detection can take up to 2 minutes.
Detergent dosage is too high.
▶ Immediate measure: mix a tablespoon of fabric softener
with 0.5 l of water and pour this mixture into the left
compartment (not for outdoor, sportswear and down
textiles).
Reduce the amount of detergent for the next wash
▶
with an equal load.
Low spin speed is set.
Set a higher spin speed for the next wash.
▶
Anti wrinkle is activated.
Select a suitable program for the type of fabric.
▶
Unbalance control system compensates for
imbalance through reduced spin speed.
Redistribute the laundry in the drum.
▶
Remark: If possible, place large and small items of
laundry together in the drum. Different sized laundry
is more evenly distributed during the spin cycle.
Start the program Centrifuge.
▶
Drain pipe or water drain hose is clogged.
Clean the drain pipe and the water drain hose.
▶
Drain pipe or water drain hose is kinked or
pinched.
Make sure that the drain pipe and the water
▶
drain hose are not kinked or pinched.
Advertisement
Table of Contents
