Download Print this page

Shanty 2 CHIC DIY Turned Leg Bench Manual

Supply List

Item

4' x 8' x 3/4" plywood

1 x 3 x 6'

18" turned leg

1-1/4" pocket hole screws

Wood glue

Finish of choice

material to upholster the seat

DIY Turned Leg Bench

Quantity

Description

Pine or whitewood board

See website article for the legs we used

Optional. You could also plank the top instead.

Table of Contents

Do you have a question about the DIY Turned Leg Bench and is the answer not in the manual?

Page 1 DIY Turned Leg Bench Copyright © 2014 Shanty-2-Chic.com Supply List Item Quantity Description 4’ x 8’ x 3/4” plywood 1 x 3 x 6’ Pine or whitewood board 18” turned leg See website article for the legs we used 1-1/4” pocket hole screws...
Page 2 Drill pocket holes for 1-1/4” pocket hole screws as indicated by the arrows. -2-c DIY T hanTY urneD ench...
Page 3 Attach the bottom panel to the lower rails. Make sure you have access to both pocket holes on the rails to connect the legs in the next step. Use wood glue at every wood joint in this project. This bench will be built upside down.
Page 4 Upholster the plywood that will be used as the seat. You can also just plank the top if you do not want to upholster anything. Before you attach the seat sand and finish the bench frame as you wish. Attach the seat with 1-1/4”...