Shanty 2 CHIC Easy DIY Cooler Manual

Supply List

Item

1 x 4 x 8'

1 x 2 x 8'

1 x 3 x 8'

2 x 3 x 4'

2-1/2" zinc narrow hinges

Rubber sink stopper

Sink flange

Silicone Sealant

6-1/2" zinc utility pull

1/2" U-Bolt

Ice scoop

Bottle opener

Hooks

Easy DIY Cooler

Quantity

1 set

1 squeeze tube

Description

Pine or whitewood board

For the drain

For the lid

For the Ice scoop

Table of Contents

Do you have a question about the Easy DIY Cooler and is the answer not in the manual?

Page 1 Easy DIY Cooler Copyright © 2014 Shanty-2-Chic.com Supply List Item Quantity Description 1 x 4 x 8’ Pine or whitewood board 1 x 2 x 8’ Pine or whitewood board 1 x 3 x 8’ Pine or whitewood board 2 x 3 x 4’...
Page 2 -2-C DIY C hanty ooler...
Page 3 Build the two side panels and the front and back panels with 1-1/4” pocket hole screws. The measurements in this model are for my cooler. Adjust these measurements to your cooler. Join the two side panels to the front and back. I used 1-1/4” pocket hole screws and Gorilla Wood Glue.
Page 4 Attach the legs to the body. I used my Ryobi AirStrike Cordless Brad Nailer for this step. Drop your cooler in from the top and line it up with the top of the legs and surround. Then, from below add your three 2 x 3 braces to support the cooler at the correct height.
Page 5 Assemble the lid slats and the lid frame with glue and 1-1/4” pocket hole screws Slide the slats into the frame and secure it with brad nails from the outside every 4” or so. Next I secured my cooler lid to my new wooden lid with a generous amount of silicone.