Gas Conversions; Convert From Natural Gas To Propane Gas - Whirlpool SCS3017 Owner's Manual

Gas built-in cooktop
Hide thumbs Also See for SCS3017:
Table of Contents

Advertisement

Available languages

Available languages

GAS CONVERSIONS

IMPORTANT: Gas conversions from Natural gas to Propane gas
must be done by a qualified installer. Before proceeding with
conversion, shut off the gas supply to the appliance prior to
disconnecting the electrical power.
WARNING:
This conversion kit shall be installed by a
qualified service agency in accordance
with manufacturer's instructions and all
applicable codes and requirements of the
authority having jurisdiction.
If the information in these instructions is
not followed exactly, a fire, an explosion or
production of carbon monoxide may result
causing property damage, personal injury
or loss of life.
The qualified service agency is responsible
for the proper installation of this kit. The
installation is not proper and complete
until the operation of the converted
appliance is checked as specified in the
manufacturer's instructions supplied with
the kit.
WARNING
Explosion Hazard
Use a new CSA International approved gas supply line.
Install a shut-off valve.
Securely tighten all gas connections.
If connected to propane, have a qualified person make
sure gas pressure does not exceed 14" (36 cm) water
column.
Examples of a qualified person include: licensed heating
personnel, authorized gas company personnel, and
authorized service personnel.
Failure to do so can result in death, explosion, or fire.

Convert from Natural Gas to Propane Gas

1. Turn manual shut-off valve to the closed position.
A
A. To cooktop
B. Shut-off valve (closed position)
C. Gas supply line
2. Unplug cooktop or disconnect power.
To Convert Gas Pressure Regulator
A
A. Access cap
B. Rear of cooktop
C. Gas pressure regulator
D. Gas flow
3. Determine the type of regulator you have:
Style 1: The cap has a slot and "NAT" printed on it.
Remove access cap by using a flat-blade screwdriver or coin,
turning the access cap counterclockwise.
The gas pressure regulator has two settings that are stamped
on either side of the cap. Turn the cap and reinstall into
regulator with the stamp "LP" visible from the outside of the
regulator.
B
C
B
C
D
13

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents