Whirlpool SCS3017 Owner's Manual page 16

3. Determine the type of regulator you have:
Style 1: The cap has a slot and "LP" printed on it.
Remove access cap by using a flat-blade screwdriver or coin,
turning the access cap counterclockwise.
The gas pressure regulator has two settings which are
stamped on either side of the cap. Turn the cap and reinstall
into regulator with the stamp "NAT" visible from the outside of
the regulator.
Style 2: The cap does not have a slot and requires a wrench
to be removed.
Remove the access cap by using a wrench, turning the
access cap counterclockwise.
Remove spring retainer from the cap by pushing against the
flat side of the spring retainer. Look at the spring retainer to
locate the "LP" or "NAT" position. Turn over the spring retainer
so the "NAT" is showing on the bottom. Snap the spring
retainer back into the cap. Reinstall the cap onto the regulator.
E
A. Access cap
B. Gasket
C. Gas pressure
regulator
4. For more information regarding gas installation requirements
see the Gas Supply Requirements section of your Owner's
Manual.
5. If they are installed, remove the burner grates.
Use the following chart to match the correct gas orifice spud
with the burner location and model being converted.
Natural Gas Orifice Spud Chart
Burner Rating
5,000 BTUs
6,000 BTUs
9,100 BTUs
10,500 BTUs
12,500 BTUs
17,000 BTUs
16
NAT
A
D C
NAT position
D.
LP position
E.
Size
1.09 mm
1.25 mm
1.55 mm
1.61 mm
1.74 mm A. Stamped
number
2.15 mm
Four Burner Models
Model No.
SCS3017
SCS3617
GLT3057
KGCC706
KGCC506
W3CG3014
ICS333
Five Burner Models
Model No.
GLT3657
KGCC766
KGCC566
KGCV566
Burner locations
B
A
6. Remove burner cap.
7. Using a T20
NOTE: Remove one burner base at a time and then replace
after converting. Do not disassemble entire cooktop.
A
Right Right
front rear
1.09 mm 1.74 mm
1.74 mm 1.25 mm
1.25 mm 1.74 mm
1.09 mm 1.55 mm
Right Right
Center
front rear
1.74 1.25 1.55
mm mm mm
1.25 1.74 1.55
mm mm mm
2.15 1.25 1.55
mm mm mm
C
B
A. Left front Right rear
D.
Right front
B. Left rear E.
C. Center
TORX screwdriver, remove the burner base.
® ®
A
B
A. Igniter Burner cap
C.
Burner base
electrode D.
B. Gas tube
opening
Left
Left rear
front
1.74 mm 1.55 mm
1.74 mm 1.55 mm
2.15 mm 1.55 mm
1.61 mm 1.55 mm
Left Left
front rear
1.74 1.25
mm mm
2.15 1.25
mm mm
2.15 1.25
mm mm
D
E
C
D