Advertisement
Available languages
Available languages
•
Take one of the wheels and place it on the side of the trailer frame so that
the rod of the quick release is guided through the guide in the frame.
•
Make sure that the quick-release lever remains on the outside and
therefore accessible.
•
Now attach the parts marked "inside" to the "inside" side of the quick-
release and tighten the nut only so far that the quick-release still has "air".
•
Now tighten it by bringing the lever into a position parallel to the frame.
If this does not work, or only works with great effort, you have already
tightened the nut too much. Loosen it a little and do not use excessive
force during assembly.
•
Repeat the procedure on the other side.
Caution: Make sure that the washers each fit into the corresponding
recesses in the frame and that the wheels have only minimal play.
EN
11
Advertisement
