Dual XDVDN8190 Installation & Owner's Manual page 12

XDVDN8190
Control Functions - Monitor Closed
Infrared Sensor
11
OPERATION
Mute Press MUTE to silence audio output. "MUTE" will appear in the display. Press
MUTE again to restore audio at previous volume level.
Mode
Press MODE to select between the unit's available modes, including Tuner,
DVD (which includes CD and MP3/WMA playback), iPod, Camera, SD,
Navigation and Auxiliary inputs. Each time the MODE button is pressed the
next mode is chosen. Modes of operation are indicated on the OSD. Hold the
MODE button for 3 seconds to toggle the Rear-Zone audio feature on and off.
Direct the remote control towards the infrared sensor to remotely control
numerous functions of the unit.
Power
Press PWR momentarily to turn the unit on. Press PWR for more than 3
seconds to turn the unit off.
Volume When the monitor is in the open position, the left side rotary controls the
volume, which is visible as a number from 0 to 40, to the right of the volume
icon displayed on the screen. When the icon is not displayed, turn the
rotary to display the volume level. Turning the rotary while the volume is
muted will cancel the mute function.
Note: To program the default volume level (only up to level 20) when the unit
is turned on: turn the rotary to the desired level, then push and hold the rotary
for 3 seconds to program the current volume level.
Monitor OPEN Notes:
• The angle can also be manually selected via the screen setup menu.
• The color of the LCD monitor varies between viewing angles. Select the angle
with the most optimum view for your location.
• The last position of the monitor can be saved in memory. When "TFT Auto
Open" is selected in the General Setup Menu, the monitor will return to its
last position automatically the next time the unit is turned on.
Caution • Due to its highly technological design, the XDVDN8190 faceplate is NOT
removable. Do not attempt to remove the faceplate.
• Upon installation, do not attempt to move the monitor by hand. Use the
ANGLE p/q and OPEN buttons on the front panel or the remote control.
• The unit will stop if it encounters any obstacles during the open/close
sequence. If this occurs, remove the obstacle and press OPEN again to
resume the monitor open/close sequence.