Digital Thermostat (Solid State Control); Loading The Appliance - Dometic L-2083 Installation And Operation Manual

Digital Thermostat (Solid State Control)

(See Fig. 3, page 20)
• The Digital Thermostat AUTOMATICALLY turns ON when power is applied to unit.
• The thermostat displays the interior temperature constantly.
To access, and/or change the Setpoint temperature, do the following:
1. Press the "set" Button to display the Setpoint temperature. The Setpoint is
changed with the "up" and "down" Arrow Buttons. The last entered Setpoint will stay in
memory. The control automatically returns to NORMAL mode (displaying the interior
temperature) within 5 seconds.
2. Press the "up" Button to INCREASE Setpoint temperature. When held down for a
few seconds, the change rate accelerates.
3. Press the "down" Button to DECREASE Setpoint temperature. When held down
for a few seconds, the change rate accelerates.

Loading the Appliance

All materials exposed to contact with food comply with EC directive 89/109.
Once the thermostat is set to a desired temperature, allow the unit to RUN at least
12 hours (24 hours for best results) before loading it with goods.
For proper food storage and conservation refer to the table below:
Food
Meat or fish properly
wrapped in plastic
Eggs
Butter, margarine
Cooked food, cakes and
soups (in sealed
containers and cooled)
Cold cuts, cheese,
fresh pasta, pastries,
cream, tomatoes,
puddings, chocolates,
lard
Fruit and vegetables
Operation
Storage Time
2 to 3 days
1 week
1 week
3 to 4 days
3 to 4 days
1 week
11
Position In Appliance
On the rack under the freezer
compartment
Use door compartment
Use door compartment
On the lowest rack in the refrigerator
On any rack
In the bottom of the refrigerator
❖ ❖ ❖ ❖ ❖
English