Preparation; Basic Settings - Steinbach Poolrunner HJ1009 Original Owner's Manual

When all indicators blink, the cleaning cycle is finished.
If all indicators are lit, the device has a fault. Contact customer service.
CYCLE function
11
Use this function to set the cleaning cycle.
Use the CYCLE button
11
ON/OFF function
12
Use this function to switch the device ON and OFF.
Use the ON/OFF button
12
- ON (Switches the device on and starts the selected cleaning cycle.)
- OFF (Stops the selected cleaning cycle and switches the device off at the same time.)

Preparation

Basic settings

Adjusting the nozzles
The following settings are recommendations. Adapt the basic settings to the actual properties and the
degree of soiling of your pool.
Light soiling
Use the round reference marking on the nozzle
for adjustment.
1. Set one nozzle to 15° or 30° and the other
nozzle to 45°.
The device moves faster.
Exception for lightly soiled round or oval pools:
Use the setting 15°/0°.
Medium to heavy soiling
Use the oblong reference marking on the nozzle
for adjustment.
1. Set both nozzles to 45° or 60°.
The device moves slower.
Installing the brush
The brush can improve the cleaning of your pool, depending on the conditions on site, such as type
6
and quantity of dirt or surface structure of the bottom. Only operate the device with the brush installed if
this leads to a better cleaning result.
26
to switch between the cleaning cycles.
to switch between the following functions:
9
9
1
9
2
9
9
9