Remote Control Configuration; Remote Programming; Pairing A 1-Way Or 2-Way Remote Control - Directed Electronics CLIFFORD 320.3X Owner's Manual

Remote Control Configuration

Remote Programming

The Responder LE and 1-way companion remote controls have opera-
tions that can be configured to a user's personal preferences. The fol-
lowing instruction will direct you through the available programming
options for both remote controls.
To enter programming, press and hold the
the remote emits one long beep and the transmit LED turns on to indi-
cate the main menu is accessed.
To exit programming or go back to a previous menu, press and re-
lease the button. 1 short and 1 long beep is emitted for each step
back and when programming is exited the transmit LED turns off.
Note: The 1way remote does not emit any confirmation beeps.

Pairing a 1-way or 2-way remote control

Note: The remote control may or may not emit sounds during this
operation.
Prepare the vehicle
Open
1. a door.
Turn
2. the ignition On.
Press and release then press and hold the control center button.
3.
The control center LED flashes and siren chirps one time to con-
firm the system is prepared.
Release
4. the button and proceed below.
Note: Begin pairing within 60 seconds or the system will exit (indi-
cated by a long siren chirp) and need to be prepared again.
© 2009 Directed Electronics. All rights reserved.
button for 8 seconds,
15