Producing Reports Using Elcomaster™ 2.0 - Elcometer 456 Operating Instructions Manual

R
7.2 CABLE CONNECTION
1. Connect your gauge to your PC using the optional USB connection cable. Connect the cable between
the interface on the end of the gauge and an USB port on your PC.
2. Switch on your gauge and ensure the Reading Screen is displayed.
3. Start ElcoMaster™ 2.0 and follow the instructions included with the software.
®
7.3 BLUETOOTH CONNECTION
Full instructions on how to interface your gauge with ElcoMaster™ 2.0 and download data are included in
the ElcoMaster™ 2.0 help file supplied with the software.
2.0
8 PRODUCING REPORTS USING ELCOMASTER
™
The ElcoMaster™ 2.0 software included with your Elcometer 456 gauge includes a report designed
specifically for duct deposit measurements. Follow the steps listed below to download readings from the
gauge to ElcoMaster™ 2.0 and then output the report to a printer, a file or to email. Further information can
be found in the instructions provided with your gauge and the help file contained within ElcoMaster™ 2.0.
8.1 DOWNLOAD READINGS DATA FROM GAUGE MEMORY
Before you start, interface and add your gauge to ElcoMaster™ 2.0 - refer to the instructions included with
ElcoMaster™ 2.0 software.
1. Ensure your gauge is connected - refer to the following screenshot.
2. Click on the batch or batches you want to download (hold down the Ctrl key to select multiple batches).
3. Click on the Download button.
4. Select which folder to download to and then press OK to start download.
9