System setup
Proceed as follows to set up the system.
Compatibility with Neumann.Control iPad app
•
The MA 1 – Automatic Monitor Alignment is not compatible with Neumann.Control iPad
app. Use either the one or the other.
•
Using the Neumann.Control app before, while or after using the MA 1 – Automatic Monitor
Alignment app may cause invalid alignment results. To be certain that the alignment is and
stays correct please:
o
Uninstall the Neumann.Control app from your iPad.
o
Perform a factory reset on your Neumann DSP devices (see below).
o
Use the MA 1 – Automatic Monitor Alignment app to align your system.
o
Do not use the Neumann.Control app on an aligned system.
•
Once the MA 1 software has started and connected to the loudspeakers previously stored
parameters from MA 1 alignment sessions before or from Neumann.Control setups are
deleted.
•
Neither MA 1 alignments nor Neumann.Control setups can be stored in the MA 1 software.
•
If after the MA 1 alignment procedure the Neumann.Control iPad app is connected to the
loudspeakers the MA 1 alignment will be overwritten by the iPad. To get back to the MA 1
automatic alignment the MA 1 alignment procedure must be redone or the previously
stored alignments have to be reloaded.
Connect the hardware
Connect your hardware as shown in this diagram
Set up the loudspeakers
Set the switch positions and level adjustments on the rear of your loudspeakers/subwoofer
according to the following instructions.
MA 1 – Automatic Monitor Alignment | 4